Jvc RX-8040B User Manual download pdf (Page 37)

English

Setting the speaker distance

The distance from your listening point to the speakers is another

important element to obtain the best possible sound of the Surround

and DSP modes. Set the distance from your listening point to the

speakers.

By referring to the speaker distance setting, this unit automatically

sets the delay time of the sound through each speaker so that sounds

through all the speakers can reach you at the same time.

• If you have used Quick Speaker Setup on page 32, this setting is

not required.

Measuring unit—DIST UNIT

Select which measuring unit you use.

DIST UNIT: meter Select to set the distance in meters.

DIST UNIT: feet Select to set the distance in feet.

Speaker distance—FRNTL DISTANCE,

FRNTR DISTANCE, CNTR DISTANCE,

SURRL DISTANCE, SURRR DISTANCE,

SBACK DISTANCE

Set the distance from the listening point within the range of

0.3 m (1 ft) to 9.0 m (30 ft), in 0.3 m (1 ft) intervals.

• When shipped from the factory, distance for each speaker is

set to “3.0 m (10 ft).”

Notes:

• You cannot set the speaker distance for the speakers you have

selected “NONE” (see page 34).

• This setting is not valid for the DVD MULTI playback mode.

Ex. In the above case, set the speaker distance as follows:

Front speakers (L/R): 3.0 m (10 ft)

Center speaker (C): 3.0 m (10 ft)

Surround speakers (LS/RS): 2.7 m (9 ft)

Surround back speakers (SB): 2.4 m (8 ft)

Setting the bass sounds

You can adjust subwoofer and bass sounds precisely according to

your preference.

Subwoofer output—S WFR OUTPUT

You can select the type of the signal which can be transmitted

through the subwoofer. In other words, you can determine

whether or not the bass elements of the front speaker channels

are transmitted through the subwoofer regardless of the front

speaker size setting (either “SMALL” or “LARGE”).

Select one of the following:

S WFR: LFE Select to emit only the LFE signals (while

playing Dolby Digital or DTS software) or the

bass elements of the “SMALL” front speakers

(while playing any source other than the above).

S WFR: LFE+MAIN

Select to always emit the bass elements of the

front speaker channels (MAIN). While playing

Dolby Digital or DTS software, the bass

element and the LFE signals are both emitted.

Note:

If you have selected “SUB WOOFER: NO,” this function is not

available.

2.1 m

(7 ft)

2.4 m

(8 ft)

2.7 m

(9 ft)

3.0 m

(10 ft)

3.3 m

(11 ft)

LS RS

32-38_8040[C].p65 04.5.14, 11:2935

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 133 134

Comments to this Manuals

No comments

Jvc RX-8040B User Manual Page 37

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Jvc RX-8040B