Jvc RX-8040B User Manual Page 21
- Page / 134
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
19
English
Zone 1 (Main Room) Operations
This section explains only the operations commonly used when you play any sound source in Zone 1 (main room).
See pages 26 to 29 for the Zone 2 (sub-room) operations.
• Before performing Zone 1 operations, it is recommended to finish the basic settings on pages 32 to 38.
IMPORTANT:
Check the following before or while using the buttons and controls.
For Zone 1 operations:
The ZONE 1 indicator lights up on the unit’s display.
• When using the unit:
–“ZONE2” is not shown in the unit’s main display.
• When using the remote control:
– Set the ZONE 1/ZONE 2 selector to ZONE 1.
– Check the indication shown on the remote’s display when you
press a button—this indicates the remote control operation mode
together with multi-room operation mode (either for ZONE 1 or
ZONE 2) for about two hours.
Ex. When you press DVD with ZONE 1/ZONE 2 selector set
to ZONE 1.
Turning the Power On and Off (Standby)
On the front panel:
To turn on the power, press STANDBY/ON.
The STANDBY lamp goes off, and the ZONE 1 indicator lights up
on the display.
The currently selected SPEAKERS 1 and/or 2 indicator(s) also
light(s) up on the display.
• If neither the SPEAKERS 1 nor 2 indicator is lit on the display,
see “Activating the Zone 1 Front Speakers” on page 21.
To turn off the power (into standby mode),
press
STANDBY/ON again.
The STANDBY lamp lights up.
On the remote control:
To turn on the power, press AUDIO POWER ON.
The STANDBY lamp goes off, and the ZONE 1 indicator lights up
on the unit’s display.
The currently selected SPEAKERS 1 and/or 2 indicator(s) also
light(s) up on the unit’s display.
• If neither the SPEAKERS 1 nor 2 indicator is lit, see “Activating
the Zone 1 Front Speakers” on page 21.
To turn off the power (into standby mode),
press AUDIO POWER STANDBY.
The STANDBY lamp lights up.
Notes:
• A small amount of power is consumed in standby mode. To turn the
power off completely, unplug the AC power cord.
• If you have turned off the receiver with the volume level set at more
than level “30,” the volume level will be automatically set at level
“30” next time you turn on the receiver.
• Before you turn off the receiver in Zone 1, make sure that no one is
listening to any source in Zone 2 (the ZONE 2 indicator is lit on the
display) since the Zone 2 sound will also be turned off
unexpectedly.
Canceling the Zone 1 Operations
To stop Zone 1 operations and sounds from the Zone 1 speakers,
press ZONE 1 ON/OFF on the unit or the remote control so that the
ZONE 1 indicator goes off from the display.
The currently selected front speakers indicator(s) also go(es) off
from the display (no sound will be heard in Zone 1).
To use this receiver for Zone 1 operations again, press
ZONE 1 ON/OFF again (the ZONE 1 indicator lights up).
The front speakers indicator(s) previously selected light(s) up.
Now the buttons and controls on the unit work for Zone 1
operations.
Note:
If “TURN ON ZONE1 OR ZONE2” appears on the display, press
ZONE 1 ON/OFF or ZONE 2 ON/OFF to listen to the sound in Zone 1
or in Zone 2; Otherwise, the receiver will turn off after about 1 minute.
ON/OFF ON/OFF
AUDIO POWER
TV/CATV/DBS DV D
ZONE 2
ZONE 1
ZONE 2
ZONE 1
POWER POWER
STANDBY
ON
ZONE 1
ZONE 2
ZONE 1
The last Zone 1 source appears.
The last Surround/DSP mode
appears.
The volume
level appears.
LINEAR PCM
L
R
ANALOG
VOLUME
SPEAKERS 1
ZONE 1
The ZONE 1 indicator lights up.
ZONE 2
ZONE 1
AUDIO POWER
ZONE 2
ZONE 1
STANDBY
ON
ZONE 1
16-29_8040[C].p65 04.5.14, 11:2919
- RX-8040B 1
- For Canada/pour Le Canada 2
- Introduction 3
- Table of Contents 4
- Parts Identification 5
- Front Panel 6
- How to open the front door 6
- CAUTION : SPEAKER IMPEDANCE 8
- Getting Started 9
- Speaker connections 10
- Connecting the subwoofer 10
- SURR BACK 11
- Analog connections 12
- Video component connections 13
- RIGHT LEFT 15
- Digital connections 16
- Setting up the RF rod antenna 16
- At an angle of 17
- Multi-room Operations 18
- On the front panel: 19
- On the remote control: 19
- Zone 1 (Main Room) Operations 21
- SPEAKERS 1 22
- LINEAR PCM 23
- DGTL AUTO DGTL D.D 24
- DGTL DTS 24
- Setting the Dynamic Range 25
- Attenuating the Input Signal 25
- Making Sounds Natural 25
- Dimmer Much dimmer 26
- Canceled 26
- Using the Sleep Timer 27
- Zone 2 (Sub-room) Operations 28
- Adjusting the Zone 2 Volume 30
- Activating the Zone 2 Front 31
- Speakers 31
- Muting the Zone 2 Sound 31
- 1 ZONE 2 31
- Receiving Radio Broadcasts 32
- To store the preset stations 33
- Basic Settings 34
- Basic Setting Items 35
- Setting the speakers 36
- Setting the speaker distance 37
- Setting the bass sounds 37
- Center speaker setting 38
- SMALL/LARGE NONE 38
- “DBS” appears (see page 24) 39
- Setting the Zone 2/Speakers 2 40
- Adjusting Sound 41
- EQ 1kHz, EQ 4kHz, EQ16kHz 42
- Adjustable speakers 42
- Surround and DSP modes 43
- Using the Surround Modes 44
- Digital Theater Systems, Inc 45
- PRO LOGIC 46
- SPEAKERS 1 46
- EX/ES/PLIIx 47
- Virtual 6.1-channel surround 49
- 3D Headphone mode—3D H PHONE 49
- Using the DSP Modes 50
- To cancel the DSP modes 51
- AUDIO POWER 52
- One-Touch Video Play 56
- DVD player 60
- STOP PAUSE 62
- * Initial setting 64
- Troubleshooting 65
- SOLUTION 66
- POSSIBLE CAUSE 66
- Specifications 67
- Table des matières 69
- Identification des parties 70
- Panneau avant 71
- Affichage 71
- Comment ouvrir la porte avant 71
- Pour commencer 74
- Connexions analogiques 77
- Connexion des appareils vidéo 78
- Remarque: 78
- Remarques: 79
- Fonctionnement multi-pièces 83
- Réglages de base 99
- Français 100
- OPTICAL signifie VCR1 104
- Ajustment du son 106
- Laboratories 110
- Utilisation des modes DSP 115
- Guide de dépannage 130
- Spécifications 132
- AUDIO/VIDEO CONTROL RECEIVER 133
Related products and manuals for Receivers and Amplifiers Jvc RX-8040B
(36 pages)
(126 pages)
© 2020, manymanuals.com. All rights reserved. | 1.102 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals