JVC RX-D411S User Manual download pdf (Page 26)

Turning off the sounds temporarily

From the remote control ONLY:

Press MUTING to turn off the sound

through all connected speakers and

headphones.

“MUTING” appears on the display and the volume turns off.

To restore the sound, press MUTING again.

• Pressing VOLUME +/– (or turning MASTER VOLUME control

on the front panel) also restores the sound.

NOTE

When performing Precise Surround Setup or turning the power off,

muting is automatically canceled.

Changing the display brightness

You can dim the display—Dimmer.

From the remote control ONLY:

Press DIMMER repeatedly.

• Each time you press the button, the display brightness

changes as follows:

DIMMER 1 Dims the display.

DIMMER 2 Dims the display more than DIMMER 1.

DIMMER 3 Turns off the display.

(Temporarily canceled when you operate the

receiver.)

DIMMER OFF Cancels the Dimmer (normal display).

NOTE

When performing Precise Surround Setup, Dimmer is automatically

canceled.

Selecting the digital decode mode

When “HDMI” or “DIGITAL” is selected for the audio input

setting (see page 21), this receiver automatically detects the

incoming digital signal format and sets the digital decode

mode to “DIGITAL AUTO.”

• The DIGITAL AUTO indicator lights up on the display.

If the following symptoms occur while playing Dolby Digital

or DTS software with “DIGITAL AUTO” selected, follow the

procedure below:

• Sound does not come out at the beginning of playback.

• Noise comes out while searching for or skipping chapters or

tracks.

From the remote control ONLY:

Press DECODE to select “DOLBY DIGITAL”

or “DTS.”

• Each time you press DECODE, the digital decode mode

changes as follows:

• To play back software encoded with Dolby Digital, select

“DOLBY DIGITAL.”

• To play back software encoded with DTS, select “DTS.”

NOTES

• The digital decode mode is fixed to “DIGITAL AUTO” when selecting

“USB” as the source.

• “DOLBY DIGITAL” or “DTS” is automatically reset to “DIGITAL AUTO”

in the following cases:

– When you turn off the receiver.

– When you select another source.

– When you change the audio input setting (see page 21).

The following digital signal format indicators on the display

indicate what type of signal comes into the receiver. See

pages 39 to 41 for the details of each digital signal format.

LINEAR PCM: • Lights up when Linear PCM signal comes

in.

• When the multi-channel PCM signal

comes in, “MULTI CH PCM” appears on

the display for a while.

Lights up when Dolby Digital signal comes

in.

• Flashes when “DOLBY DIGITAL” is

selected for any software other than

Dolby Digital.

Lights up when conventional DTS signal

comes in.

• Flashes when “DTS” is selected for any

software other than DTS.

96/24:

Lights up when DTS 96/24 signal comes in.

NOTE

When “DIGITAL AUTO” cannot recognize the incoming signal, no

digital signal format indicator lights up on the display.

DIGITAL AUTO = DOLBY DIGITAL = DTS =

(Back to the beginning)

20-23_BasicOP.indd 2220-23_BasicOP.indd 22 06.6.9 2:24:12 PM06.6.9 2:24:12 PM

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 56 57

Comments to this Manuals

No comments

JVC RX-D411S User Manual Page 26

Comments to this Manuals

Related products and manuals for AV receivers JVC RX-D411S