JVC RX-D411S User Manual download pdf (Page 12)

CAUTIONS:

• Use speakers with the SPEAKER IMPEDANCE indicated by

the speaker terminals (6 Ω – 16 Ω).

• DO NOT connect more than one speaker to one speaker

terminal.

7 Connecting the speakers

Turn off all components before making connections.

To connect the center speaker and the front speakers

1 Cut, twist and remove the insulation at

the end of each speaker cord.

2 Turn the knob counterclockwise.

3 Insert the speaker cord.

• For each speaker, connect the (+) and (–) terminals on

the rear panel to the (+) and (–) terminals marked on the

speakers.

4 Turn the knob clockwise.

Connecting the speakers

Do not connect the AC power cord until all other connections have been made.

7 Speaker Layout Diagram

Right surround

back speaker (SBR)

Left surround back

speaker (SBL)*

Powered

subwoofer (SW)

Center speaker (C)

Right surround speaker (SR)

Left surround speaker (SL)

Right front

speaker (R)

Left front

speaker

(L)

To connect the surround speakers and the surround back

speakers

1 Cut, twist and remove the insulation at

the end of each speaker cord.

2 Open the terminal (1), then insert the

speaker cord (2).

• For each speaker, connect the (+) and (–) terminals on

the rear panel to the (+) and (–) terminals marked on the

speakers.

3 Close the terminal.

* When using a single speaker for the surround back

speaker

You can enjoy the surround sound by one surround back

speaker. When using one surround back speaker,

– set “S BACK OUT” to “1SPK” (see page 30) and

– connect the surround back speaker to the left surround

back speaker terminal. (No sound comes from the

speaker if you connect it to the right surround back

speaker terminal.)

7 Connecting the powered subwoofer

By connecting a subwoofer, you can enhance the bass or

reproduce the original LFE signals recorded in digital software.

Connect the input jack of a powered subwoofer to the

SUBWOOFER OUT jack on the rear panel, using a cord with

RCA pin plugs (not supplied).

• Refer also to the manual supplied with your subwoofer.

After connecting all the speakers and/or subwoofer, perform

Precise Surround Setup to adjust the speaker settings

automatically (see pages 16 to 19).

NOTE

You can place a subwoofer wherever you like since bass sound is non-

directional. Normally place it in front of you.

SBRSBL

(SB*)

12 3

12 43

06-15_Connection.indd 806-15_Connection.indd 8 06.6.9 2:23:33 PM06.6.9 2:23:33 PM

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 56 57

Comments to this Manuals

No comments

JVC RX-D411S User Manual Page 12

Comments to this Manuals

Related products and manuals for AV receivers JVC RX-D411S