JVC RX-D411S User Manual download pdf (Page 24)

1 Turn on the power

Press STANDBY/ON (or AUDIO on the

remote control).

The standby lamp goes off and the current source lamp lights

in red.

To turn off the power (into standby):

Press STANDBY/ON (or AUDIO on the remote control)

again.

The standby lamp lights in red.

NOTES

• A small amount of power is consumed in standby mode. To turn the

power off completely, unplug the AC power cord.

• Turning a source component on before turning the receiver on

may cause a noise or interrupt the sound and picture. In this case,

turn both the source component and the receiver off, then turn the

receiver on before turning the source component on.

Basic operations

Source lamps

Current source name appears.

2 Select the source to play

On the front panel:

Turn SOURCE SELECTOR until the source

name you want appears on the display.

The source lamp corresponding to the selected source lights

in red.

• As you turn SOURCE SELECTOR, the source changes as

follows:

DVR/DVD: Select this for the DVD recorder or DVD player.

VCR: Select this for the VCR.

VIDEO: Select this for the component connected to the

VIDEO IN jacks on the rear of the receiver.

TV: Select this for the TV.

USB: Select this for the PC component.

FM: Select this for the FM broadcast.

AM: Select this for the AM (MW) broadcast.

From the remote control:

Press one of the source selecting buttons.

• For “FM” and “AM,” press FM/AM.

Each time you press the button, the band alternates

between “FM” and “AM.”

NOTE

When you connect a video component other than DVD recorder and

DVD player to the HDMI VIDEO(VCR) IN terminal or COMPONENT

VIDEO jacks on the rear of the receiver, you need to select either

“VIDEO” or “VCR” for each terminal according to the component you

connect (see page 34).

DVR/DVD Ô VCR Ô VIDEO Ô TV Ô USB Ô FM Ô

AM Ô (Back to the beginning)

132

3 Adjust the volume

To increase the volume, turn MASTER

VOLUME control clockwise (or press

VOLUME + on the remote control).

To decrease the volume, turn MASTER

VOLUME control counterclockwise (or press

VOLUME – on the remote control).

• When you adjust the volume, the volume level indication

appears on the display for a while.

CAUTION:

Always set the volume to the minimum before starting any

sources. If the volume is set at its high level, the sudden blast

of sound energy can permanently damage your hearing and/

or ruin your speakers.

NOTE

The volume level can be adjusted within the range between “0”

(minimum) and “50” (maximum).

20-23_BasicOP.indd 2020-23_BasicOP.indd 20 06.6.9 2:24:04 PM06.6.9 2:24:04 PM

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 56 57

Comments to this Manuals

No comments

JVC RX-D411S User Manual Page 24

Comments to this Manuals

Related products and manuals for AV receivers JVC RX-D411S