JVC RX-D411S User Manual download pdf (Page 10)

Before installation

7 General precautions

• Be sure your hands are dry.

• Turn the power off to all components.

• Read the manuals supplied with the components you are

going to connect.

7 Locations

• Install the receiver in a location that is level and protected

from moisture and dust.

• The temperature around the receiver must be between –5°C

and 35°C.

• Make sure there is good ventilation around the receiver.

Poor ventilation could cause overheating and damage the

receiver.

• Leave sufficient distance between the receiver and the TV.

7 Handling the receiver

• Do not insert any metal object into the receiver.

• Do not disassemble the receiver or remove screws, covers,

or cabinet.

• Do not expose the receiver to rain or moisture.

• Do not pull on the power cord to unplug the cord. When

unplugging the cord, always grasp the plug so as not to

damage the cord.

• When you are away on travel or otherwise for an extended

period or time, remove the plug from the wall outlet. A small

amount of power is always consumed while the power cord

is connected to the wall outlet.

The receiver has a built-in cooling fan which operates

while the receiver is turned on. Be sure to leave enough

ventilation to obtain sufficient cooling effect.

CAUTION:

Do not connect the AC power cord until all other connections

have been made.

Checking the supplied accessories

Check to be sure you have all of the following supplied

accessories. If anything is missing, contact your dealer

immediately.

• Remote control (× 1)

• Batteries (× 2)

• AM (MW) loop antenna (× 1)

• FM antenna (× 1)

• Dedicated earphone-type microphones (× 1)

• Core filter (× 1)

Getting started

Putting the batteries in the remote

control

Before using the remote control, put two supplied batteries

first.

1 Press and slide the battery cover on the

back of the remote control.

2 Insert the batteries.

Make sure to match the polarity: (+) to (+) and (–) to (–).

3 Replace the cover.

If the range or effectiveness of the remote control decreases,

replace the batteries. Use two R6(SUM-3)/AA(15F) type dry-cell

batteries.

• Supplied butteries are for initial setup. Replace for

continued use.

CAUTION:

Follow these precautions to avoid leaking or cracking cells:

• Place batteries in the remote control so they match the

polarity: (+) to (+) and (–) to (–).

• Use the correct type of batteries. Batteries that look similar

may differ in voltage.

• Always replace both batteries at the same time.

• Do not expose batteries to heat or flame.

When using the remote control, aim the remote control

directly at the remote sensor on the front panel.

Remote sensor

12 3

06-15_Connection.indd 606-15_Connection.indd 6 06.6.9 2:23:29 PM06.6.9 2:23:29 PM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 56 57

Comments to this Manuals

No comments

JVC RX-D411S User Manual Page 10

Comments to this Manuals

Related products and manuals for AV receivers JVC RX-D411S