JVC RX-7520VBK User Manual download pdf (Page 30)

English

On the front panel:

You can also use the buttons on the front panel to adjust the

Surround modes. However, no test tone is available when using the

buttons on the front panel. So make adjustments while listening to

the sound of the source played back.

Set the analog or digital input mode for the

source you like to hear and start playing.

When playing back software encoded with Dolby Digital and DTS

Digital Surround, select the digital input mode (see page 14).

Press SURROUND ON/OFF to

activate Surround mode.

Each time you press the button, Surround mode

turns on and off alternately.

• If you are playing back software encoded with Dolby Digital

multichannel, “DOLBY DIGITAL” is selected.

• If you are playing back software encoded with DTS Digital

Surround, “DTS SURROUND” is selected.

• If you are playing back any software other

than above, you can select “PL II MUSIC” or

“PL II MOVIE” according to the source by

pressing SURROUND MODE. (

PRO

LOGIC II indicator lights up on the display.)

If you like to adjust sound, go to step

Adjust the speaker output levels.

Press ADJUST repeatedly until one

of the following indications (with the

current setting)* appears on the

display.

* “0” is the initial setting. If you have already changed the

setting, another number (level) will be shown.

CENTER : To adjust the center speaker output level

(–10 to +10).

REAR L : To adjust the left rear speaker output level

(–10 to +10).

REAR R : To adjust the right rear speaker output level

(–10 to +10).

Press CONTROL UP 5/DOWN ∞

to adjust the selected speaker

output levels.

Repeat steps

and

to adjust the other

speaker levels.

SURROUND MODE

SURROUND ON/OFF

SOUND

ADJUST SETTING

L C

S.WFR

LS RS

CH-

LFE

SPK

PRO LOGIC ΙΙ

DIGITAL AUTO

LINEAR PCM

TEST

TEST TONE L

(Left front speaker)

TEST TONE LS

(Left rear speaker)

TEST TONE RS

(Right rear speaker)

TEST TONE C

(Center speaker)

TEST TONE R

(Right front speaker)

TEST

REAR R

REAR L

CENTER

Press SOUND.

The 10 keys are activated for sound adjustments.

Press TEST to check if you can hear the

sounds through all the speakers at the

equal level.

“TEST TONE L” starts flashing on the display and a test tone

comes out of the speakers in the following order:

Notes:

• You can adjust the speaker output levels without outputting the

test tone.

• No test tone comes out of the center speaker when “CNTR SP”

is set to “NONE.”

• No test tone comes out of the rear speakers when “REAR SP”

is set to “NONE.”

Adjust the speaker output levels (–10 to +10).

Adjust the center speaker and rear speakers levels comparing to

the sound from the front speakers.

• To adjust the center speaker level, press

CENTER +/–.

• To adjust the left rear speaker level, press

REAR•L +/–.

• To adjust the right rear speaker level, press

REAR•R +/–.

Press TEST again to stop the test

tone.

CONTROL

DOWN UP

EN23-29.RX-7520V[C]f.pm5 02.2.14, 4:33 PM27

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 45 46

Comments to this Manuals

No comments

JVC RX-7520VBK User Manual Page 30

Comments to this Manuals

Related products and manuals for AV receivers JVC RX-7520VBK