JVC AX-V5BK User Manual

For Customer Use:Enter below the Model No. and Serial No. which are located either on the rear, bottom or side of the cabinet. Retain this information

EnglishPage 5About the speaker impedance of the speakersCAUTION:When connecting speakers, use speakers with the same SPEAKER IMPEDANCE indicated bythe

EnglishPage 6Connecting the subwoofer speakerConnect the input jack of a powered subwoofer to the SUBWOOFER OUT jack on the rear panel, using a cablew

EnglishPage 7Video component connectionsVHSVCRTUNERCDOUT(REC)IN(PLAY)OUT(REC)IN(PLAY)VIDEOVIDEOOUT(REC)MONITOROUTIN(PLAY)AUDIORIGHTLEFTTAPEPHON

EnglishPage 8POWER_ON —OFFR6P (SUM-3)/AA (15F)Connecting the Power CordBefore plugging the amplifier into an AC outlet, make sure that all connectio

EnglishPage 9Basic OperationsThe following operations are commonly used when you play any sound source.Turning the Power On and Off (Standby)On the fr

EnglishPage 10SPEAKERS12_ON —OFFMASTER VOLUME–+On the front panelFrom the remote controlVOLUME–+Selecting different sources for picture and soundYo

EnglishPage 11Recording a SourceYou can record any source playing through the amplifier to a cassette deck connected to the TAPE jacksand VCR connecte

EnglishPage 12SETTINGBasic SettingsSome of the following settings are required after connecting and positioning your speakers in your listeningroom, w

EnglishPage 13When the shut-off time comes, the amplifier turns off (into standby mode) automatically.To check or change the time remaining until the

EnglishPage 14One Touch OperationThis amplifier can memorize the optimum sound setting for each playing source.About the One Touch OperationJVC’s One

G-1Warnings, Cautions and Others/Warnung, Achtung und sonstige Hinweise/Mises en garde, précautions et indications diverses/Waarschuwingen,voorzorgen

EnglishPage 15Using the Preset SEA ModesThe preset SEA (Sound Effect Amplifier) modes give you control over the way your music sounds.Note:The preset

EnglishPage 16From the remote control:1. Press SEA ON/OFF so that the SEA indicator lights up on the display.The previously selected mode is recalled

EnglishPage 17Using the Surround ProcessorThe built-in surround processor provides three types of surround programs — Dolby Pro Logic, Dolby 3-Channel

EnglishPage 18ADJUST3. Press ADJUST so that the Control %%%%% / fififififi / @@@@@ / ##### buttons work for surround settings.The lamp above the button lig

EnglishPage 19Speaker Arrangements for Dolby SurroundThe following illustrations show how to obtain the optimum sound environment for various Dolby Su

EnglishPage 20SURROUNDPreparing for Dolby SurroundThe amplifier memorizes two sets of Dolby Surround adjustments; one for Pro Logic and the other for

EnglishPage 216. Press Control %%%%% / fififififi until “–DELAY +” appears on the display.7. Press Control @@@@@ / ##### to adjust the delay time of the re

EnglishPage 22From the remote control:If you have already set the center speaker size following the procedure described on page 13, you can use therem

EnglishPage 23SURROUNDUsing Dolby SurroundOnce you have set the Dolby Surround adjustments, you can use the same adjustments every time you wantto enj

EnglishPage 24COMPU LINK Remote Control SystemThe COMPU LINK remote control system allows you to operate JVC audio components through the remotesensor

G-2ATTENTIONAfin d’éviter tout risque d’électrocution, d’incendie, etc.:1. Ne pas enlever les vis ni les panneaux et ne pas ouvrir le coffretde l’appa

EnglishPage 25Using the Remote ControlYou can operate JVC audio and video components with the amplifier’s remote control, since control signals for JV

EnglishPage 26IMPORTANT:To operate JVC video components using this remote control:• Aim the remote control directly at the remote sensor on the VCR or

EnglishPage 27TroubleshootingUse this chart to help you solve daily operational problems. If there is any problem you cannot solve, contactyour JVC se

EnglishPage 28SpecificationsAmplifierOutput Power At Stereo Operation Front Channels 50 watts per channel, min. RMS, driven into 4 ohms at 1 kHz wi

VICTOR COMPANY OF JAPAN, LIMITEDJVC0497OFYOTKJEMEN, GE, FR, NL, SP, ITAX-V5BK(EF)_0023-001A_Cover 97.4.24, 11:50 AM2

G-3Caution –– POWER switch and STANDBY/ON button!This apparatus is provided with a POWER switch to be able tominimize power consumption for safe us

G-4Caution: Proper VentilationTo avoide risk of electric shock and fire and to protect from damage.Locate the apparatus as follows:Front: No obstructi

EnglishPage 1Table of ContentsSwitches, Buttons and Controls...

EnglishPage 2Switches, Buttons and ControlsBecome familiar with the buttons and controls on the amplifier before use.Front Panel1 Remote sensor2 Displ

EnglishPage 3Getting StartedThis section explains how to connect stereo components and speakers to the amplifier, and how to connectthe power supply.B

EnglishPage 4Connecting the SpeakersYou can connect the following speakers:• Two sets of front speakers to produce normal stereo sound• One set of rea