JVC RX-7520VBK User Manual download pdf (Page 19)

English

Selecting the Video Input

Terminal

This receiver is equipped with the component video input terminals

for the DVD player which give you higher picture quality. When you

use the component video input terminals for the DVD player, change

the video input terminal setting.

Before you start, remember....

There is a time limit in doing the following steps. If the setting is

canceled before you finish, start from step

again.

Press SETTING repeatedly until

“VIDEO IN DVD ” or “VIDEO IN

VCR ” appears on the display.

• Select “VIDEO IN DVD” to select the video input terminal for

the DVD player and “VIDEO IN VCR” for the VCR.

After 2 seconds, the display changes to show the current setting.

Press CONTROL UP 5/DOWN ∞

to select the appropriate type of

the video input terminal.

• Each time you press the button, the display

changes as follows:

COMPONENT : Select this when you connect the DVD

player or VCR to the component video

input terminals.

S/C : Select this when you connect the DVD player

or VCR to the S-video or composite video

input terminal.

Note:

Without changing the video input terminal setting, you can see the

picture through the video input terminals, but cannot use the AV

COMPU LINK remote control system correctly (see page 32).

Basic Settings

“NO” for the subwoofer, “LARGE” for the front speakers,

and “SMALL” for the center and rear speakers are initial

settings. To get best possible sound, change the subwoofer

and speaker settings to fit your listening conditions.

Setting the Speaker Information

To obtain the best possible sound or effect from Surround modes

(see pages 26 to 29), register the following speakers and subwoofer

information after all connections are completed.

The following are items you can set:

• Subwoofer information—SUBWOOFER

• Speaker size—FRNT SP, CNTR SP, REAR SP

• Speaker distance—UNIT, FRNT DIS, CNTR DIS, REAR DIS

• Crossover frequency—CROSS

• Low frequency effect attenuator—LFE ATT

• Dynamic range compression—D. COMP

Before you start, remember....

There is a time limit in doing the following steps. If the setting is

canceled before you finish, start from step

again.

Subwoofer information

Press SETTING repeatedly until

“SUBWOOFER” (with the current

setting)* appears on the display.

* “NO” is the initial setting. If you have already changed the

setting, “YES” will be shown.

Press CONTROL UP 5/DOWN ∞ to

subwoofer or not.

• Each time you press the button, the subwoofer

setting alternates between “YES” and “NO.”

YES : Select this when you have connected a subwoofer.

You can adjust the subwoofer output level

(see page 20).

NO : Select this when you have not connected or have

disconnected a subwoofer.

ST SETTING

CONTROL

DOWN UP

COMPONENT

(Component)

S/C

(S-video/Composite)

L C

CH-

SPK

DIGITAL AUTO

LINEAR PCM

Remote

NOT

L C

S.WFR

CH-

LFE

SPK

DIGITAL AUTO

LINEAR PCM

ST SETTING

CONTROL

DOWN UP

Remote

NOT

EN10-22.RX-7520V[C]f.pm5 02.2.14, 4:32 PM16

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 45 46

Comments to this Manuals

No comments

JVC RX-7520VBK User Manual Page 19

Comments to this Manuals

Related products and manuals for AV receivers JVC RX-7520VBK