JVC KD-LX10 Instruction Manual download pdf (Page 20)

20

ENGLISH

To select the external component to use

— EXT INPUT

You can connect the external component to the

CD changer jack on the rear using the Line Input

Adaptor KS-U57 (not supplied).

To use the external component as the playback

source through this unit, you need to select

which component — CD changer or external

component — to use. When shipped from the

factory, “CHANGER” is selected as the external

component.

• CHANGER: To use the CD changer.

• LINE INPUT: To use the external

component other than the CD

changer.

To make the front panel look flat (hiding

the control panel) — FLAT PANEL

When operating the receiver using the remote

control, you can hide the control panel to make

the front panel look flat. When shipped from the

factory, “FLAT OFF” is selected.

• FLAT ON: The control panel will not

come out when you turn on

the unit.

To use the control panel,

press 4 so that the

control panel comes out. If no

operation is done for about

10 seconds, it automatically

goes back into the receiver.

• FLAT OFF: You can use the control panel

normally.

Note:

When “FLAT ON” is selected, you can eject a CD by

holding 4 .

To turn the demo mode on or off

— DEMO MODE

You can turn the demo mode on or off. When

shipped from the factory, “DEMO ON” is

selected.

• DEMO ON: Turns the demo mode on.

The demonstration will start

automatically if no sound

comes in for 3 minutes.

• DEMO OFF: Turns the demo mode off.

Note:

If the unit has been reset (and the power is on),

demonstration will start if no sound comes in for

about 10 seconds.

Controlling the volume

automatically (Audio Cruise)

You can select the proper cruise mode for your

car.

This unit changes the volume level automatically

(at 3 possible levels) based on the driving speed

of your car by detecting the alternator’s

generating frequency (Audio Cruise).

If you want to use this mode, follow the

procedure below. When shipped from the factory,

this mode is set to “CRUISE OFF.”

• CRUISE 1: Select this if your car is

relatively quiet.

• CRUISE 2: Select this if your car is

relatively loud.

The volume increase rate is

twice as much as that of the

CRUISE 1 setting.

• CRUISE OFF: Cancels Audio Cruise.

1

Press and hold SEL (Select) for

more than 2 seconds so that one of

the PSM items appears on the

display. (See page 18.)

2

Select “CRUISE MODE.”

3

Select the desired setting.

As you turn the control dial, the Audio

Cruise mode changes as follows:

CRUISE 1

CRUISE 2

CRUISE OFF

EN17-22.KD-LX100[J]f 1/8/01, 10:23 AM20

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 85 86

Comments to this Manuals

No comments