JVC UX-A70MD User Manual download pdf (Page 20)

– 15 –

English

Tuning in a Station

Press FM/AM.

The unit automatically turns on and tunes in the

previously tuned station (either FM or AM.)

• Each time you press the button, the band alternates

between FM and AM.

Press and hold ¢ or 4 until the station

frequencies start changing continuously in the main

display.

• ¢ : to increase the frequencies.

• 4 : to decrease the frequencies.

The unit starts searching stations and stops when a

station of sufficient signal strength is tuned in.

• If an FM program is broadcast in stereo, the STEREO

indicator lights on the display.

To stop during searching, press ¢ or 4.

When you repeatedly press ¢ or 4

The frequency changes step by step.

Setting the AM Tuner Interval Spacing

Some countries space AM stations 9 kHz apart, and some

countries use 10 kHz spacing.

When shipped, the built-in AM tuner is set to 9 kHz

spacing.

On the main unit ONLY:

To set the AM tuner to the 10 kHz spacing, be sure that

the unit is turned off, but is plugged into a wall outlet.

While holding ¢, press

To set it back to the 9 kHz spacing, be sure that the unit is

turned off, but is plugged into a wall outlet.

While holding 4, press

To change the FM reception mode

When an FM stereo broadcast is noisy or hard to receive,

you can change the FM reception mode to improve the

reception.

On the remote control ONLY:

Press FM MODE.

• Each time you press the button, FM reception mode

alternates between “STEREO” and “MONO.”

STEREO : Normally select this.

In this mode, you can hear stereo sound

when a program is broadcast in stereo. In

addition, static noise between stations

will be erased while tuning.

MONO : Select this when an FM stereo broadcast

is noisy or hard to receive. Reception

improves though stereo effect is lost.

The MONO indicator lights on the

display.

Presetting Stations

You can preset 30 FM and 15 AM stations manually.

In some cases, test frequencies have been already memorized

for the tuner since the factory examined the tuner preset

function before shipment. This is not a malfunction. You can

preset the stations you want into memory by following the

presetting method.

• There is a time limit in doing the following steps. If the

setting is canceled before you finish, start from step

again.

On the remote control ONLY:

Tune in the station you want to preset.

• See “Tuning in a Station” to the left.

Press SET.

The preset number starts flashing as follows:

• When you select an FM station in step

• When you select an AM station in step

• The unit always starts from the preset number 1.

Ex. An FM station is tuned in.

EN14-16.UX-A70MD[USUBUJ]_f 00.12.4, 4:30 PM15

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 53 54

Comments to this Manuals

No comments

JVC UX-A70MD User Manual Page 20

Comments to this Manuals

Related products and manuals for CD players JVC UX-A70MD