JVC MX-J100 User Manual download pdf (Page 16)

– 11 –

English

Listening to FM and AM Broadcasts

Tuning in a Station

Press FM/AM.

The unit automatically turns on and tunes in

the previously tuned station (either FM or

AM).

• Each time you press the button, the band alternates

between FM and AM.

Select a station.

On the unit:

Press and hold TUNING –

or TUNING + for more

than 1 second.

On the remote control:

1) Press TUNING MODE so that

“MANUAL” appears on the

display.

2) Press and hold 4¥1 or

¢¥¡ for more than 1

second.

The unit starts searching for stations

and stops when a station of sufficient

signal strength is tuned in.

If a program is broadcast in stereo, the ST (stereo)

indicator lights up.

To stop during searching, press TUNING – or TUNING +

(or 4¥1 or ¢¥¡ on the remote control).

When you press TUNING – or TUNING + (or

4¥1 or ¢¥¡ on the remote control) briefly

and repeatedly

The frequency changes step by step.

To change the FM reception mode

When an FM stereo broadcast is hard to receive or

noisy, press FM MODE on the remote control so

that the MONO indicator lights up on the display.

Reception improves.

To restore the stereo effect, press FM MODE

again so that the MONO indicator goes off.

In this stereo mode, you can hear stereo sounds when a

program is broadcast in stereo.

The FM reception mode is restored even when the unit is

turned off.

Presetting Stations

You can preset 30 FM, 15 AM stations.

In some cases, test frequencies have been already memorized

for the tuner since the factory examined the tuner preset

function before shipment. This is not a malfunction. You can

preset the stations you want into memory by following the

presetting method.

• There is a time limit in doing the following steps. If the

setting is canceled before you finish, start from step 1

again.

Tune in the station you want to preset.

• See “Tuning in a Station” to the left.

Press PROGRAM/SET.

The PRGM flashes on the display.

Press PRESET – or + to

select a preset number.

Press PROGRAM/SET again.

The tuned station in step 1 is stored in the

preset number selected in step 3.

• Storing a new station on a used number

erases the previously stored one.

When you unplug the AC power cord or if a power

failure occurs

The preset stations will be erased in a few days. If this happens,

preset the stations again.

Tuning in a Preset Station

Press FM/AM.

The unit automatically turns on and tunes in

the previously tuned station (either FM or

AM).

• Each time you press the button, the band alternates

between FM and AM.

Select a preset number.

On the unit:

Press PRESET – or +.

On the remote control:

1) Press TUNING MODE so

that “PRESET” appears on

the display.

2) Press 4¥1 or

¢¥¡.

FM/AM

PROGRAM/SET

FM/AM

MHz

PRGM

PRESET +–

FM MODE

PROGRAM/SET

TUNING +

TUNING

TUNING MODE

EN01-11.MX-J100[U,US]/f 00.4.27, 2:35 PM11

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 27 28

Comments to this Manuals

No comments

JVC MX-J100 User Manual Page 16

Comments to this Manuals

Related products and manuals for CD players JVC MX-J100