JVC RX-730R User Manual Page 52

  • Download
  • Add to my manuals
  • Print
  • Page
    / 58
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 51
Page 47
English
4 Press one of the buttons on the remote mode section.
If possible, select the source corresponding to the target remote control’s usage.
Notes:
Since no signal have been preset for the EXT.1 and EXT.2 modes, you can store signals from the target
remote control without losing any preset signals.
If you want to store a signal into the TV or VCR button on the POWER section, you can skip this step.
5 Press one of the buttons (illustrated to the left), to which you want to assign a signal from the
target remote control.
The SEND/LEARN indicator starts flashing.
Note:
If the ERROR indicator lights red, you have already stored a signal. To change the stored signal, go to
the next step. If you do not want to change it, press another button.
6 While the SEND/LEARN indicator is flashing, press the button on the target remote control,
the signal of which you want to assign to the button of this remote control you have pressed in
step 5.
The SEND/LEARN indicator stops flashing and remains lit, and the ERROR indicator also lights red
but soon goes off.
Remote: Inside
SEND/LEARN ERROR
SEND/LEARN ERROR
Lights
Buttons you can assign
signals to
Remote: Outside
SEND/LEARN ERROR
SEND/LEARN ERROR
Flashes
SEND/LEARN ERROR
SEND/LEARN ERROR
SEND/LEARN ERROR
Lights
Lights
Lights
Operating the Other Manufacturers’ Audio/Video Components
The remote control supplied with the receiver can learn and memorize the signals used for the other
manufactures’ remote control unit. By storing these signals, you can operate the other manufacturers’ audio/
video components.
Storing the signals
Before storing another manufacturer’s signals, make sure that manufacturer’s remote control unit (hereafter
called “target remote control”) actually works.
1 Place the two remote controls on a level surface with signal transmitting windows facing each
other.
Leave a space of 5 to 10 cm (2 to 4 inches) between the two remote controls; otherwise, storing may
be failed.
2 Open the outside panel of this remote control.
3 Press LEARN so that the SEND/LEARN indicator lights up (green).
Remote: Inside
CANCELLEARN
SEND/LEARN ERROR
Lights
SEQUENTIAL PROGRAM KEY
ABC
SLEEP
VCR TV AUDIO
SEND/LEARN ERROR
ONE TOUCH
OPERATION
TV VCR
Remote: Inside
432
7/P6
010 +10
8
1
5
9
PRESET
CHANNEL
TEST
TV
VOLUME
DELAY
+
CENTER
+
REAR
TV/VIDEO
PTY SELECT
PTY SEARCH
PTY SELECT
DISPLAY MODE
+
FM
MODE/MUTE
TAPE
TAPECD
VCRTV
EXT.1
EXT.2
5 to 10 cm
(2 to 4 inches)
RX-730RBK(EF)0054-001A.En.42-52 97.7.25, 7:06 PM47
Page view 51
1 2 ... 47 48 49 50 51 52 53 54 55 56 57 58

Comments to this Manuals

No comments