JVC RX-5001VGD User Manual

For Customer Use:Enter below the Model No. and Serial No. which are located either on the rear, bottom or side of the cabinet. Retain this information

7EnglishPutting Batteries in the Remote ControlBefore using the remote control, put two supplied batteries first.When using the remote control, aim th

8EnglishTurning the Power On and Off (Standby)On the front panel:To turn on the power, press STANDBY/ON .The STANDBY lamp goes off. The name of thecur

9EnglishAdjusting the VolumeOn the front panel:To increase the volume, turn MASTERVOLUME clockwise (+).To decrease the volume, turn itcounterclockwise

10EnglishAttenuating the Input SignalWhen the input level of the playing source is too high, the soundswill be distorted. If this happens, you need to

11EnglishChanging the Source NameWhen you have connected an MD recorder to the TAPE/MD jackson the rear panel: Change the source name shown on the dis

12EnglishTo store the sound settings1. Press ONE TOUCH OPERATION.The ONE TOUCH OPERATION lamp lights up, then thepreviously memorized settings are rec

13EnglishSetting the AM Tuner Interval SpacingSome countries space AM stations 9 kHz apart, and other countriesuse 10 kHz spacing. When shipped, the s

14EnglishSelecting the FM Reception ModeWhen an FM stereo broadcast is hard toreceive or noisyYou can change the FM reception mode while receiving an

15EnglishUsing the DSP ModesThe built-in Surround Processor provides three types of the DSP (Digital Signal Processor) mode — 3D-PHONIC mode,DAP (Digi

16EnglishAvailable DSP Modes According to the Speaker ArrangementAvailable DSP modes will vary depending on how many speakers are used with this recei

Warnings, Cautions and Others / Avisos, precauciones y otras notas /Advertêcias, precauções e outras notas /G-1CAUTIONTo reduce the risk of electrical

17EnglishAdjusting the DAP ModesBefore you start, remember...• Make sure that you have set the speaker information correctly(see page 11).• There is a

18EnglishFrom the remote control:1. Press SOUND CONTROL.The 10 keys are activated for sound adjustments.2. Press SURROUND repeatedlyuntil the DAP mode

19English8. ONLY FOR JVC TheaterSurround:Press MULTI CURSOR @ / # toselect an effect level you want.• Each time you press the button, the effectlevel

20EnglishUsing the DVD MULTI Playback ModeThis receiver provides the DVD MULTI playback mode for reproducing the analog discrete output mode of the DV

21EnglishCOMPU LINK Remote Control SystemThe COMPU LINK remote control system allows you to operate JVC audio components through the remote sensor ont

22EnglishOperating JVC’s Audio/Video ComponentsYou can operate JVC’s audio and video components with this receiver’s remote control, since control sig

23EnglishVCRYou can always perform the following operations :VCR:Turns on or off the VCR.VCR CH +/–: Changes the channels on the VCR.After pressing V

24EnglishPROBLEMThe display does not light up.No sound from speakers.Sound from one speaker only.Continuous hiss or buzzing during FMreception.Occasio

25EnglishSpecificationsAmplifierOutput PowerAt Stereo operation: 100 W per channel, min. RMS, bothchannels driven into 8 Ω at 1 kHz, with nomore than

26EnglishFM tuner (IHF)Tuning Range: 87.50 MHz to 108.00 MHzUsable Sensitivity: Monaural: 12.8 dBf (1.20 µV/75 Ω)50 dB Quieting Sensitivity:Monaural:

G-2EspañolEnglishPortuguêsCaution: Proper VentilationTo avoid risk of electric shock and fire and to protect from damage.Locate the apparatus as follo

JVC0400HIMMDWJEINEN, SP, PR, CHMains (AC) Line Instruction (not applicable for Europe, U.S.A., Canada, Australiaand U.K.)Instrucción sobre la línea de

1EnglishTable of ContentsParts Identification... 2Getting Started... 3Befor

2EnglishParts IdentificationBecome familiar with the buttons and controls on the receiver before use.Refer to the pages in parentheses for details.Fro

3EnglishANTENNAAMEXTAMLOOPFM 75 COAXIALAMLOOPANTENNAAMEXTFM 75 COAXIALAMLOOPANTENNAAMEXTFM 75 COAXIALGetting StartedThis section explains how to

4EnglishRIGHT LEFTREARSPEAKERSCENTERSPEAKERTurn the loop until you have the best reception.Notes:• Make sure the antenna conductors do not touch any o

5EnglishConnecting the subwoofer speakerYou can enhance the bass by connecting a subwoofer.Connect the input jack of a powered subwoofer to theSUBWOOF

6EnglishVIDEOAUDIOLEFTRIGHTMONITOROUTOUT(REC)IN(PLAY)OUT(REC)IN(PLAY)DVDVCRVHSVideo component connectionsUse the cables with RCA pin plugs (not suppli