Jvc RM-P2580 User Manual download pdf (Page 23)

The electrical standards applied to the SERIAL-1 and SERIAL-

2 connectors can be switched between RS-232C and RS-422A

using pins 7 and 8 of the rear panel DIP switch.

4. CONNECTIONS

REAR PANEL CONNECTORS

TO CAMERA

Connection to control the camera. (The RM-P2580 is compatible with a TK-C675B camera.)

Communication is carried out by MULTIDROP FULL DUPLEX (RS-485, FULL DUPLEX).

SERIAL-1, -2

Connect a frame switcher, etc.

(D-sub 9-pin, male connectors)

–

RM-P2580 CAMERA 1

–

CAMERA 2

Attach or remove each cable by pushing

down and holding each terminal connector,

as shown above.

Hold.

DIP SW

Set

Connector

SERIAL-1

SERIAL-2

OFF

RS-232C

RS-422A

Pin No. Signal Name

RXD (Data input)

TXD (Data output)

DTR (Control output)

GND

DSR (Control input)

RTS (Control input)

CTS (Control output)

Pin No. Signal Name

RXD- (Data input)

TXD- (Data output)

GND

TXD+ (Data output)

RXD+ (Data input)

Signals when the RS-232C is set

Internally connected.

Internally connected

via a driver.

Signals when the RS-422A/485 is set

Internally connected.

Set the mode and select the electrical standard for the SERIAL connector.

DIP Switch

4312 8756

(Default: All OFF)

Description OFF ONPin No.

System mode selection

Cannot be used.

(Ensure that they are set to OFF.)

SERIAL-1 electrical standard selection

SERIAL-2 electrical standard selection

A mode

RS-232C

B mode

RS-422A

Note

Communication speed is 9600 bps.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 34 35

Comments to this Manuals

No comments

Jvc RM-P2580 User Manual Page 23

Comments to this Manuals

Related products and manuals for Photo Accessories Jvc RM-P2580