JVC TH-A10R User Manual download pdf (Page 8)

To attach non-slip rubbers to the center

speaker

Attach the supplied non-slip rubbers at three points on the bottom of

the center speaker.

Installation

Example ——————————————————

CAUTIONS:

• For safety reasons, always ensure that there is sufficient place

behind the powered sub-woofer.

• If the front and rear speakers are placed on the floor, always

ensure that they are level.

To hang satellite speakers from the wall

Use the supplied bracket to fix satellite speakers to the wall.

CAUTION: ATTACHING THE BRACKETS ON THE WALL

When attaching the brackets on the wall, have them attached

to the wall by a qualified person.

DO NOT attach the brackets on the wall by yourself to avoid

an unexpected damage of their falling from the wall, caused

by incorrect attachment or weakness in the wall.

Location of attachment to wall:

Care is required in selecting a location for attaching satellite

speakers to the wall. Injury to personnel, or damage to

equipment, may result if the speakers are attached in a

location which interferes with daily activities.

Attaching speakers to the bracket ————————

1. Use the screw supplied to attach the speaker to

the bracket.

Tilting the speaker to the front

Tilting left-right

2. Adjusting the angle of the satellite speakers

The angle of the speaker may be adjusted in the front-rear and

left-right directions along the channel in the bracket.

When adjusting the angle, loosen the screw slightly, make the

adjustment, and then tighten the screw firmly.

Bracket

CAUTION:

If the screw is not tightened

firmly, it may cause injury to

personnel or damage to

equipment.

1 cm (7/16”)

5 cm (2”)

Front side

Bottom

Satellite speaker

(front left speaker)

Satellite speaker

(front right speaker)

Center speaker

Powered

sub-woofer

Satellite speaker

(rear left speaker)

Satellite speaker

(rear right speaker)

Screw

Center unit

The rear speakers are

placed behind the

listening position.

Non-slip rubber

The non-slip rubbers are adhesive.

Peel off the seal before applying.

Attach non-slip rubbers at the three

points shown in the diagram.

Attach two rubbers at left and right at

the front of the speaker, and one in the

middle at the rear.

TH-A10R[B]1/f 00.7.3, 7:57 PM4

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 67 68

Comments to this Manuals

No comments

JVC TH-A10R User Manual Page 8

Comments to this Manuals

Related products and manuals for DVD players JVC TH-A10R