JVC MX-KC50 User Manual download pdf (Page 8)

Getting Started

Connecting the AM Antenna

Rear Panel of the Unit

• Even when connecting an outside AM antenna, keep the indoor AM loop connected.

CAUTION:

• To avoid noise, keep antennas away from the System, the connecting cord and the AC power cord.

Connecting the Speakers

1. Open each of the terminals to connect the speaker wire leads.

2. Connect the speaker cords to the Speaker terminals of the Unit.

Connect the gray (+) and gray with black stripe (–) cords of the right side speaker to the red (+) and black (–) terminals marked RIGHT

on the System.

Connect the gray (+) and gray with black stripe (–) cords of the left side speaker to the red (+) and black (–) terminals marked LEFT on

the System.

3. Close each of the terminals.

CAUTIONS:

• A TV may display irregular colors if located near the speakers. If this happens, set the speakers away

from the TV.

• Use speakers with the correct impedance only. The correct impedance is indicated on the rear panel.

AM loop antenna (Supplied)

Attach the AM loop to its base by snapping the

tabs on the loop into the slot in the base.

Turn the loop until you

have the best reception.

AM antenna wire (not supplied)

If reception is poor, connect the outside antenna.

Right side (rear view)

Left side (rear view)

Gray with

black stripe

Gray

Gray with

black stripe

Gray

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 31 32

No comments

JVC MX-KC50 User Manual Page 8