JVC MX-K50 User Manual download pdf (Page 12)

– 7 –

English

6-16

[ ]

SPEAKER

Press and hold the clamp of the AM terminal

on the rear of the unit.

Insert the end of the AM loop antenna cord

into the terminal.

• If the AM loop antenna wire is covered

with vinyl, remove the vinyl by twisting it

as shown in the diagram.

Release the finger from the clamp.

Turn the AM loop antenna until you have the

best reception.

To connect an outdoor AM antenna

When reception is poor, connect a single vinyl-covered wire

to the AM terminal and extend it horizontally. (The AM loop

antenna must remain connected.)

For better reception of both FM and AM

• Make sure the antenna conductors do not touch any other

terminals and connecting cords.

• Keep the antennas away from metallic parts of the unit,

connecting cords, and the AC power cord.

Press and hold the clamp of the speaker

terminal on the rear of the unit.

Insert the end of the speaker cord into the

terminal.

Match the polarity (colors): Red (+) to red (+) and black

(–) to black (–).

• If the wire is covered with vinyl, remove

the vinyl by twisting it as shown in the

diagram.

Release the finger from the clamp.

IMPORTANT:

• Use only speakers with the same speaker impedance as

indicated by the speaker terminals on the rear of the

unit.

• DO NOT connect more than one speaker to one speaker

terminal.

AM antenna

Vinyl-covered wire

(not supplied)

AM loop antenna

(supplied)

Connecting Speakers

From right

speaker’s

terminals

Speaker

cord

(red/black)

From left

speaker’s

terminals

Red

ANTENNA

FM 75

[ ]

Black

Speaker

cord

(red/black)

2, 3

EN01-12.MX-K50[U].pm6 02.5.21, 11:20 AM7

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 63 64

Comments to this Manuals

No comments

JVC MX-K50 User Manual Page 12

Comments to this Manuals

Related products and manuals for Cassette players JVC MX-K50