Jvc SR-VS30E User Manual download pdf (Page 85)

Masterpage:Right-Full-NoTitle0

85

Filename [SR-VS30EK_4-EN.fm]

Page 85 February 1, 2002 2:16 pm

TIMER RECORDING

SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION

1. Timer recording won’t work.

●

The clock and/or the timer have been set

incorrectly.

Re-perform the clock and/or timer

settings.

●

The timer is not engaged. Press

#

and confirm that “

#

” is displayed

on the front display panel.

●

Timer recording may not work when the

recorder’s input mode is set to “F-1” for

recording on the DV deck.

Set the channel position other than “F-1”

before engaging to Timer-Standby mode.

2. Timer programming is not possible.

●

Timer recording is in progress. Timer programming can’t be performed

while a timer recording is in progress.

Wait until it finishes.

3. “

#

” and “

[

” on the front display

panel won’t stop blinking.

●

The timer is engaged but there’s no

cassette loaded.

For the VHS deck

Insert a VHS (or S-VHS) cassette with the

record safety tab intact, or cover the hole

using adhesive tape.

For the DV deck

Insert a Mini DV cassette with the erase

protection switch set to “REC”.

●

The end of the tape was reached during

timer recording.

The programme may not have been

recorded in its entirety. Next time make

sure you have enough time on the tape to

record the entire programme.

●

VHS deck

The loaded cassette has had its record

safety tab removed.

Remove the cassette and cover the hole

with adhesive tape, or insert a cassette

with the record safety tab intact.

●

DV deck

The loaded cassette has had its erase

protection switch set to “SAVE”.

Remove the cassette and set the erase

protection switch to “REC”.

4. “

#

” blinks for 10 seconds and the

Timer mode is disengaged.

●

#

has been pressed when there are no

programs in memory, or the timer

record information has been

programmed incorrectly.

Check the programmed data and re-

program as necessary, then press

#

again.

5. The VIDEO Plus+ system does not

timer-record properly.

●

The recorder’s channel positions have

been set incorrectly.

Refer to “Guide Program Number Set”

(

墌

pg. 82) and re-perform the procedure.

6. The power shuts off and “

[

” won’t

stop blinking.

●

The end of the tape was reached during

Instant Timer Recording.

The programme may not have been

recorded in its entirety. Next time make

sure you have enough time on the tape to

record the entire programme.

SR-VS30EK_1.book Page 85 Friday, February 1, 2002 2:33 PM

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 91 92

Comments to this Manuals

No comments