JVC RX-F10S User Manual download pdf (Page 9)

COAXIAL

AM LOOP

FM 75

AM EXT

ANTENNA

Snap the tabs on the loop

into the slots of the base

to assemble the AM (MW)

loop antenna.

Connecting the FM and AM (MW) antennas

AM (MW) loop

antenna (supplied)

If AM (MW) reception is poor,

connect an outdoor single vinyl-

covered wire (not supplied).

AM (MW) antenna connection

Connect the AM (MW) loop antenna supplied to the AM LOOP

terminals.

Turn the loop until you have the best reception.

• If the reception is poor, connect an outdoor single vinyl-covered

wire (not supplied) to the AM EXT terminal. Keep the AM (MW)

loop antenna connected.

FM antenna connection

Connect the FM antenna supplied to the FM 75 Ω COAXIAL

terminal as a temporary measure.

Extend the supplied FM antenna horizontally.

• If the reception is poor, connect an outdoor FM antenna (not

supplied). Before attaching a 75 Ω coaxial cable with a

connector (IEC or DIN 45325), disconnect the supplied FM

antenna.

FM antenna (supplied)

NOTES

• If the AM (MW) loop antenna wire is covered with

vinyl, remove the vinyl while twisting it as shown

on the right.

• Make sure the antenna conductors do not touch

any other terminals, connecting cords and power

cord. This could cause poor reception.

Getting started

If FM reception is poor, connect an

outdoor FM antenna (not supplied).

01-05RX-F10[B]_f.p65 04.2.13, 16:405

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 46 47

No comments

JVC RX-F10S User Manual Page 9