JVC RX-F10S User Manual download pdf (Page 10)

Getting started

SUBWOOFER

OUT

CENTER SURROUND SURROUND

BACK

SPEAKERS

LEFTRIGHT LEFTRIGHT

FRONT

CAUTION: SPEAKER

IMPEDANCE 6

LS RS

Connecting the speakers

Turn off all components before making connections.

Twist and remove the insulation at the end of each

speaker cord.

Press and hold the clamp of the speaker terminal

(1), then insert the speaker cord (2).

• For each speaker, connect the (+) and (–) terminals on the

rear panel to the (+) and (–) terminals marked on the

speakers.

Release the finger from the clamp.

CAUTIONS:

• Use speakers with the SPEAKER IMPEDANCE indicated by the

speaker terminals (6 Ω – 16 Ω).

• DO NOT connect more than one speaker to one speaker

terminal.

Connecting the speakers

Speaker Layout Diagram

Powered

subwoofer

(SW)

Surround back

speaker (SB)

Connecting the powered subwoofer

By connecting a subwoofer, you can enhance the bass or

reproduce the original LFE signals recorded in digital software.

Connect the input jack of a powered subwoofer to the

SUBWOOFER OUT jack on the rear panel, using a cord

with RCA pin plugs (not supplied).

• Refer also to the manual supplied with your subwoofer.

After connecting all the speakers and/or a subwoofer, set the

speaker setting information properly to obtain the best possible

surround effect. For details, see pages 16 to 19.

NOTE

You can place a subwoofer wherever you like since bass sound is

non-directional. Normally place it in front of you.

Right front speaker

(R)

Left front speaker

(L)

Right surround

speaker (RS)

Left surround

speaker (LS)

Center speaker (C)

06-11RX-F10[B]_f.p65 04.2.13, 16:406

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 46 47

Comments to this Manuals

No comments

JVC RX-F10S User Manual Page 10

Comments to this Manuals

Related products and manuals for AV receivers JVC RX-F10S