JVC RX-80PGD User Manual download pdf (Page 9)

Page 6

English

SPEAKER

IMPEDANCE

/ OHMS

SPEAKER

LOAD

SELECTOR

4 ~ 6

8 ~ 16

LOW

HIGH

–

RIGHT LEFT

SPEAKER

LOAD

SELECTOR

LOW

HIGH

FRONT SPEAKERS

RIGHT

CAUTION: SPEAKER IMPEDENCE

Connecting the Speakers

You can connect the following speakers:

• Two pairs of front speakers to produce normal stereo sound.

• One pair of rear speakers to enjoy the surround effect.

• One center speaker to produce more effective surround effect (to emphasize human voices).

• One subwoofer to enhance the bass.

For each speaker (except for subwoofer), connect the black (–) and red (+) terminals on the rear panel to the

black (–) and red (+) terminals marked on the speakers. For connecting a subwoofer, see page 7.

CAUTION:

Use speakers with the SPEAKER IMPEDANCE indicated by the speaker terminals.

Connecting the front speakers

Cut, twist and remove the insulation at the end of each speaker signal cable first, and then, connect the front

speakers to the FRONT SPEAKERS terminals by using the cables.

You can connect two pairs of front speakers (one pair to the FRONT SPEAKERS 1 terminals, and another

pair to the FRONT SPEAKERS 2 terminals).

Right SpeakerLeft Speaker

1 Turn the knob

counterclockwise.

2 Insert the speaker

signal cable.

3 Turn the knob

clockwise.

Notes:

• To obtain the best possible output power from the receiver, and to prevent the receiver from

being overheated, the receiver has the SPEAKER LOAD SELECTOR which should be set to

match the impedance of the connected speakers.

Set this selector according to the indications by the FRONT SPEAKERS terminals.

• When you connect two pairs of the speakers to the FRONT SPEAKERS terminals, use the

speakers having the impedance within the same range.

EN01-25.RX-80P[UF]/f 98.8.31, 1:27 PM6

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Comments to this Manuals

No comments

JVC RX-80PGD User Manual Page 9

Comments to this Manuals

Related products and manuals for AV receivers JVC RX-80PGD