JVC RX-80PGD User Manual download pdf (Page 53)

Page 50

English

Troubleshooting

Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact

your JVC service center.

PROBLEM

The display does not light

up.

No sound from speakers.

Sound from one speaker

only.

Continuous hiss or buzzing

during FM reception.

Occasional cracking noise

during FM reception.

The analog discrete output

sound of the DVD player

cannot be reproduced

correctly.

No colors on the on-screen

display.

Howling during record

playing.

Remote control does not

work.

POSSIBLE CAUSE

The power cord is not plugged in.

Speaker signal cables are not

connected.

The SPEAKERS 1 and 2 buttons

are not set correctly.

An incorrect source is selected.

Mute is activated.

Speaker signal cables are not

connected properly.

The balance is set to one extreme.

Incoming signal is too weak.

The station is too far away.

An incorrect antenna is used.

Antennas are not connected

properly.

Ignition noise from automobiles.

An incorrect source is selected.

The sound setting of the DVD

player is incorrect.

The color system of the

connected TV is not PAL.

Your turntable is too close to

speakers.

The remote control mode selector

is not set correctly.

There is an obstruction in front of

the remote control sensor on the

receiver.

Batteries are weak.

SOLUTION

Plug the power cord into an AC outlet.

Check speaker wiring and

reconnect if necessary.

Press SPEAKERS 1 and 2 correctly.

(See page 13.)

Select the correct source.

Press MUTING to cancel the mute.

Check speaker wiring and reconnect if

necessary.

Adjust the balance properly.

Connect an outside FM antenna or

contact your dealer.

Select a new station.

Check with your dealer to be sure you

have a correct antenna.

Check connections.

Move the antenna farther from

automobile traffic.

Select “DVDMULTI” as the source on

the receiver.

Check the sound setting of the DVD

player.

Connect an PAL TV.

Move speakers away from the

turntable.

Set the selector correctly either to the

“TV / VCR / TUNER / CD / DVD /

VCD” position or to “SOUND

CONTROL” position.

Remove the obstruction.

Replace batteries.

EN44-52.RX-80P[UF]/f 98.8.31, 1:53 PM50

1 2 ... 48 49 50 51 52 53 54 55 56

Comments to this Manuals

No comments