JVC DLA-G150CLE User Manual download pdf (Page 56)

DLA-G150CLU

DLA-G150CLE

1-56

No.51931

Connecting to Various Devices

Connecting the Power Cord

After all devices have been finished being connected, connect the supplied power cord. At this time, do not yet turn on the

MAIN POWER switch.

CAUTIONS

To prevent fire and electric shock, observe the

following:

• When you do not use devices, pull out their power cords

from wall outlets.

• Do not connect the devices with power cords other than

those supplied.

• Do not use mains voltage other than the power voltage

indicated.

• Do not scar, damage, or work on the power cords. Also, do

not put a heavy object on, heat, or stretch the power cords,

otherwise they may be damaged.

• Do not insert or pull out the plugs with a wet hand.

Insert the supplied power cord into the

power input terminal of the projector.

Insert the main plug of the supplied

power cord into a suitable wall outlet.

Note

• The power cord for the United Kingdom is only included as

a special accessory when shipped to the

United Kingdom

. It

is not included when shipped to European continent

countries.

CAUTIONS

• Since the power requirement of the projector is high, insert

the power plug directly into a wall outlet.

• Use the supplied power cord with the ferrite core only.

• Do not remove the ferrite core from the supplied power

cord; Otherwise, there may be a possibility that a harmful

interference occurs.

Removing the Lens Cap

Remove the lens cap before using the projector.

Notes

• The lens cap is supplied with the lens unit (optional). It

should be attached to the lens when the projector is not

used.

• Do not operate the projector with the lens cap attached.

Doing so can deform the lens cap because of the heat. A

metallic lens cap can get hot and cause injury.

Power cord (supplied)

for United Kingdom

for European continent countries

Ferrite core

for United Kingdom

for European

continent countries

Connecting to Various Devices

ENGLISHDEUTSHFRANÇAISITALIANOESPAÑOL

Connecting to DVI

Before connection, be sure to turn off both the projector and computer devices.

• Read thoroughly the manual that comes with each device.

Note

• Other connections are the same as in the connection example for IBM PC or IBM compatible PCs.

How to attach the ferrite core

Attach the ferrite core when using the S-video cable or infrared remote sensor extension unit which are sold separately.

However, use a cable that can be wound once.

Release the stopper at each end and

open the ferrite core.

Wind the cord around the ferrite core.

Attach the ferrite core about 3 cm from the end of the

cord.

Close the ferrite core with the cord

inside until you hear it click shut.

Note

• When connecting, connect the terminal which is at the

ferrite core end of the cord to the projector.

DOS/V

(DVI VIDEO BOARD)

DVI (DVI-D 24pin Cable)

(Available separately)

Click!

Stoppers

Wind the cable once.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 79 80

Comments to this Manuals

No comments

JVC DLA-G150CLE User Manual Page 56

Comments to this Manuals

Related products and manuals for Data projectors JVC DLA-G150CLE