Jvc UX-G1 User Manual download pdf (Page 13)

Tuning in to a Station

Press TUNER/BAND to select either

“FM” or “AM.”

The unit automatically turns on and tunes in to

the previously received station—either FM or

AM (MW).

• Each time you press the button, the band alternates

between FM and AM (MW).

Press and hold ¢ or 4

(or ¡/¢ or 4/1 on

the unit) for more than 1

second.

• ¢ (¡/¢):

Increases the frequencies.

• 4 (4/1):

Decreases the frequencies.

The unit starts searching for stations and stops when a

station of sufficient signal strength is tuned in.

• If an FM program is broadcast in stereo, the ST (stereo)

indicator lights up on the display (only when the

reception is good).

To stop during searching, press ¢ or 4 (or ¡/¢ or

4/1 on the unit).

When you repeatedly press ¢ or 4 (or ¡/¢ or

4/1 on the unit)

The frequency changes step by step.

Listening to FM and AM (MW) Broadcasts

TUNER/

BAND

To change the FM reception mode

On the remote control ONLY:

When an FM stereo broadcast is hard to receive

or noisy, press FM MODE so that “MONO”

appears and the MONO indicator lights up on the

display. Reception will improve.

To restore the stereo effect, press FM MODE again so that

“STEREO” appears and the MONO indicator goes off. In

stereo mode, you can hear stereo sound when a stereo

program is broadcast.

To reduce the beat when listening to an AM (MW)

station—Beat Cut

On the remote control ONLY:

While recording an AM (MW) broadcast, beats

may be heard (which are never heard when

listening to the broadcast without recording it).

If this occurs, press BEAT CUT repeatedly, while

recording, until the beats are reduced.

• Each time you press the button, the display alternates

between “CUT–1” and “CUT–2.”

FM MODE

BEAT CUT

Continued

UX-G1[B]_rev_06tuner_f.p65 05.1.28, 11:28 AM10

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

Comments to this Manuals

No comments

Jvc UX-G1 User Manual Page 13

Comments to this Manuals

Related products and manuals for Acoustics Jvc UX-G1