JVC LT-42E910 User Manual download pdf (Page 6)

400mm

Bracket holes

How to attach the stand

NOTE:

• Unplug the AC cord from the AC outlet.

• Ensure that unpacking and transfer of the unit is carried out by two or more people.

• Before beginning this process, assure that TV is laid on a clean, safe, and cushioned space to avoid any

damage to the unit.

• Do not touch or press the TV-screen, glass might break under pressure.

Place the TV on its front onto a table.

Align the stand’s bottom-plate (supplied) as seen here.

It will ﬁ t in only one direction.

Hold the unit and attach the stand slowly, as shown in Figure 1.

How to remove the stand

When you transport this product, remove the stand and pack ﬂ at against the back of the unit in the carton. To remove the

stand, perform these steps in reverse order.

For wall mounting, the base must be removed. To disconnect the base/stand remove the 4 screws from the back.

Finally secure the bottom-plate with 4 screws (supplied) as indicated by the arrows in Figure 2.

Be sure to follow the instructions. Insufficient tightening or incorrect installation of the stand will not support

your unit correctly, and could result in damage or injury from tip-over.

•

LCD PANEL SIDE

Figure 1

Figure 2

Notes when mounting the LCD TV on a wall

If the unit is to be mounted on the wall, contact the retailer where you purchased the LCD TV for advice, and have the

equipment professionally installed. Incomplete or improper installation may cause injury to you, and/or damage to the LCD

TV.

Bracket holes: To attach a wall mounting bracket (not supplied) remove the screw, then attach where indicated in the

drawing right.

This manufacturer recommends professional installation.

Utilize an appropriate bracket and fasteners, sufficient to accommodate the size and weight of the unit.

Assure the wall to which the unit is to be mounted will safely support the size and weight of the unit, using the bracket and

fasteners you have selected.

Keep cords and cables connected to this flat panel display out of reach of children.

To hang the television on a wall, remove these screws and then remove a stand. Before performing work spread cushioning

over the base area to lay the TV on.

•

Bracket holes

200mm

Screws

M6 × 10

Illustration is LT-42E910

M8 × 15

Screws

Illustration is LT-46E910

3CQ0221B_En.indd 63CQ0221B_En.indd 6 10/6/10 3:52:17 PM10/6/10 3:52:17 PM

1 2 3 4 5 6 7 8 9 10 11 ... 55 56

Comments to this Manuals

No comments

JVC LT-42E910 User Manual Page 6

Comments to this Manuals

Related products and manuals for LCD TVs JVC LT-42E910