JVC FS-V100 User Manual download pdf (Page 8)

CAUTION: Make all connections before plugging the System into an AC power outlet.

Connecting the Speakers

For each speaker, connect one end of the speaker wire to the speaker terminals on the back of the System.

1. Open each of the terminals and insert the speaker wires firmly, then close the terminals.

2. Connect the red (+) and black (–) wires of the right side speaker to the red (+) and black (–) terminals marked R on the System.

Connect the red (+) and black (–) wires of the left side speaker to the red (+) and black (–) terminals marked L on the System.

CAUTION:

If a TV is installed near the speakers, the picture on the TV may be distorted. If this happens, set the

speakers away from the TV.

Connecting External Equipment

You can connect an audio equipment — used only as a playback device.

Connect the audio output terminals on the other equipment and the LINE IN (AUX) terminals on the rear, using an audio cord (not supplied).

SPEAKERS

IMPEDANCE

MIN 4Ω

Right speaker (rear side)

Left speaker (rear side)

Black

LINE IN

(AUX)

To audio output

Signal cord (not supplied)

MD recorder or

cassette deck (not supplied)

Pin-plug x 2Pin-plug x 2

EN01-09.FS-V100[J]f 12/12/00, 10:33 AM4

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

No comments

JVC FS-V100 User Manual Page 8