WR-MG270Marine CaseINSTRUCTIONSUnterwassergehäuseBEDIENUNGSANLEITUNGBoîtier sous-marinMANUEL D’UTILISATIONOnderwaterhuisGEBRUIKSAANWIJZINGCarcasa subm
20Always perform maintenance on the marine case after you have finished recording.Salt crystal or dirt will accumulate inside the marine case if maint
21z The front glass will fog if it is dirty.HLet it dry completely in a shaded area.z Do not leave the marine case in direct sunlight.z Doing so may c
WR-MG270Marine CaseINSTRUCTIONSUnterwassergehäuseBEDIENUNGSANLEITUNGBoîtier sous-marinMANUEL D’UTILISATIONOnderwaterhuisGEBRUIKSAANWIJZINGCarcasa subm
ENGLISHDEUTSCHFRANÇAISNEDERLANDSCASTE.ESP.ITALIANOРУССКИЙPOLSKIO-ring Maintenance ManualO-Ring-WartungshandbuchManuel d’entretien du joint d’étanchéit
● O-ring is a type of seal used to make underwater cameras, strobes and other diving instruments, waterproof.It looks like a big, thick rubber band.●
● Check for hair, dirt, sand, salt, dust, and other foreign matter¹ Even small foreign matter can cause water leakage.● Check for foreign matter that
● Apply silicone grease on the O-ringThe O-ring needs to be re-greased when its surface appears dry.Be sure to remove the O-ring and apply the silicon
● Insert the O-ring after inspectionMake sure no foreign matter is adhered when placing the greased O-ring back to the groove.Do not pull too strongly
O-ring Maintenance ManualO-Ring-WartungshandbuchManuel d’entretien du joint d’étanchéitéOnderhoudshandleiding voor de O-ringManual de mantenimiento de
12In order to use this product safelyPreparation (A Pg. 16)• Check that there is no dirt, cracks, or damage to the O-ring.• Always apply grease to the
13 3. Check that there are no scratches or cracks on the marine case every time you use it.The marine case must withstand water pressure with use. Rep
14Procedures for Using the Supplied Maintenance KitDrying agentPrevents fogging inside the marine case.Insert it at the back of the base attached to t
15Silicone clothWash the marine case with fresh water, and wipe the outer side of the whole case with the silicone cloth after drying.BuckleHexagonal
16 1. Main casing gripAttach the strap provided as shown in the diagram above. 2. Zoom leverZoom (tele/wide) while shooting. 3. RingCommercially avail
17ASetup the camera.z For models equipped with light, turn off the light.z Open the lens cover.z Set to the shooting mode (video/still image).¹ Even w
18ISeal the marine case.z Make sure that the O-ring is not twisted, and that you did not forget to attach it.z Make sure that foreign objects (strap,
19BPress the video recording start/stop button or the still image lever to start recording.CWhen you have finished recording, press and hold the power
Comments to this Manuals