JVC RX-D212B User Manual download pdf (Page 13)

2. Check if the drivers are correctly installed.

1. Open the Control Panel on your PC:

Select [Start] = [Control Panel].

2. Select [System] = [Hardware] = [Device Manager] =

[Sound, video and game controllers] and [Universal Serial

Bus controllers].

• The following window appears, and you can check whether

the drivers are installed.

Now the PC is ready for playback through the USB

connection.

After installation is completed, you can use your PC as the

playback source. The PC automatically recognizes the receiver

whenever the USB cable is connected between the PC and the

receiver while the receiver is turned on.

• When not using the PC as the playback source, disconnect the

transmitter or the USB cable.

To play back sounds on the PC, refer to the manuals supplied

with the sound reproduction application installed in the PC. Start

the application after the USB device is recognized.

If no sound comes from the speakers, check the following

items:

– check if the USB device is recognized properly.

– check if the playback software in your PC is compatible with the

USB device.

– open the Control Panel on your PC, select [Sounds and Audio

Devices] = [Audio] tab = [Sound playback] = [Default device],

and check if [Default device] is set to [USB Audio DAC].

– select “USB” as the source.

– connect the USB cable correctly.

NOTES

• DO NOT turn off the receiver or disconnect the USB cable while

installing the drivers and for several seconds while your PC is

recognizing the receiver.

• If your PC does not recognize the receiver, disconnect the USB

cable and connect it again. If it does not work yet, restart

Windows

• The installed drivers can be recognized only when the USB

cable is connected between the receiver and your PC.

• The sound may not be played back correctly—interrupted or

degraded—due to your PC settings and PC specifications.

• Use a USB cable (version 1.1 or later). Recommended cord

length is 1.5 m.

* Microsoft

, Windows

98 SE, Windows

Me, Windows

2000,

and Windows

XP are registered trademarks of Microsoft

corporation.

USB connection

This receiver is equipped with a USB terminal. You can enjoy

sound reproduced through your PC.

When you connect your PC for the first time, follow the procedure

below.

• Remember you cannot send any signal or data to your PC from

this receiver.

IMPORTANT:

Check if your PC equipped with the CD-ROM drive is running on

Windows

98 SE*, Windows

Me*, Windows

2000* or Windows

XP* and prepare its CD-ROM.

Preparation

1. Turn on your PC.

• If the PC has been turned on, quit all the applications now

running.

2. Turn on the receiver, and select the source as “USB.”

3. Set the volume to minimum.

IMPORTANT:

Always set volume to “0” when connecting or disconnecting other

equipment.

4. Connect the receiver to the PC using a USB cable (not

supplied).

• Use “USB series A plug to B plug” cable when connecting.

How to install the USB drivers

The following procedure is described using the English version of

Windows

XP. If your PC is running on a different version of

operation system or language, the screens shown on your PC's

monitor will differ from the ones used in the following procedure.

1. The USB drivers are installed automatically.

• If the USB drivers are not installed automatically, install the

USB drivers by following the instructions on the PC’s

monitor.

USB

USB cable

(not supplied)

10-11RX-D211S212B[J]f.p65 06.3.17, 11:4811

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 47 48

Comments to this Manuals

No comments

JVC RX-D212B User Manual Page 13

Comments to this Manuals

Related products and manuals for AV receivers JVC RX-D212B