JVC VN-V25U User Manual

IP CAMERAVN-V25USTART-UP GUIDELST0629-001AThank you for purchasing this JVC product.Before operating this unit, please read theinstructions carefully

10Getting StartedSide / RearJ[MONITOR OUT] Monitor Output Selection SwitchUse this switch to select the availability of output from the N [MONITOR OUT

11Surveillance Using the Built-in ViewerVN-V25U comes with a built-in ActiveX JPEG Viewer and MPEG4 Viewer.JPEG images and MPEG4 images of VN-V25U can

12Getting StartedAlarmVN-V25U comes with a motion detection feature and dual alarm input.By motion detection or alarm input, actions such as mail deli

13Connection / Installation1.Check the mounting method of the lens to be used before mounting● The default method used for this camera is CS mount. To

14Connection / InstallationElectricity can be supplied to this product either by using the PoE or connecting to the AC 24 V power supply.䢇 When power

15Connecting to the AC 24 V power supplyConnect this product to the AC 24 V power supply when the PoE is not used.Caution:

16Connection / InstallationConnect the camera to a hub or computer using a LAN cable.䡵 When connecting to a hubMake use of a straight cable.䡵 When con

17Connect the alarm input/output terminals with external devices, such as a sensor or buzzer.Plug/Unplug the cable while pressing the button as shown

18Connection / InstallationUse the screw hole on the camera mounting bracket to mount this camera to a fixer or rotating platform.䡵 Mounting the camer

19This product comes with an inner tripod base at the bottom surface. You can use the inner tripod base by removing the camera mounting bracket that i

2Getting StartedSafety PrecautionsCAUTION:TO REDUCE THE RISK OF ELECTRICSHOCK. DO NOT REMOVE COVER (ORBACK). NO USER-SERVICEABLE PARTSINSIDE.REFER SER

20Connection / InstallationInner Tripod Base Mounting ScrewsMake use of 1/4-20UNC screws. The length of the mounting screw shall be between 6 mm to 7

21●Ensure that there is sufficient network bandwidth for the data volume to be sent out by VN-V25U. Do not send multicast stream that exceeds the band

22Connection / InstallationWhen only MPEG4 images are distributed, the maximum number of distributions is determined by the preset bit rate. When a di

23Network SettingsSetting the IP address for VN-V25UThere are two methods to set the IP address for VN-V25U as follows.(A) Assigning an IP address to

24Network Settings䢇 IP address setting at the computerSet the computer to an IP address that enables communication with VN-V25U.1.Click [Start]● Selec

25䢇 Changing the IP address using the Internet Explorer1.Launch the Internet Explorer on the computer2.When proxy settings are enabled in the Internet

26Network Settings䢇 Changing the IP address using the Internet Explorer (continued)4.Launch the Internet ExplorerNote:

276.The top page of VN-V25U appears7.The [Basic] page with the IP address settings appears when DHCP is not in useA confirmation screen appears. Press

28Network SettingsWhen the IP address of VN-V25U is knownWhen the IP address of VN-V25U is known, it can be changed by accessing the built-in web page

29OperationThis product comes with a JPEG Viewer and an MPEG4 Viewer. Each of these viewers functions separately.䡵 Using the JPEG Viewer enables displ

3● This installation should be made by a qualified service person and should conform to all local codes.● This installation shall be in accordance wit

30OperationInternet Explorer Setup1.Launch the Internet Explorer on the computer2.When proxy settings are enabled in the Internet Explorer, follow the

313.If ActiveX controls and plug-ins of the Internet Explorer is disabled, follow the steps below to enable it● Click [Trusted sites] under [Tool]-[In

32OperationInstalling the built-in viewer1.Enter the URL of the built-in viewer in the address field of Internet ExplorerFor example, if the IP addres

33Screen Configuration of JPEG Viewer● When the JPEG Viewer is first installed, it is set to play back at 15 fps by default.ABCDA DisplaySize Switches

34OperationExiting the JPEG ViewerTo exit, press the [close] button at the top right of the window.● During the next startup of the built-in viewer, l

35Screen Configuration of MPEG4 ViewerNote:

36OperationExiting the MPEG4 ViewerTo exit, press the [close] button at the top right of the window.● During the next startup of the built-in viewer,

37Shortcut for Built-in ViewerCreating a shortcut for the built-in viewer on the Desktop screen of the computer saves you the trouble of having to ent

38OthersCamera UnitPick-up element : 1/4-inch progressive scan CCDEffective pixels : Approx. 330,000 pixels 659 (H) ⳯ 494 (V)Lens Mount : C/CS mou

39Dimension [Unit: mm]T Specifications and appearance of this product are subject to changes for improvement without prior notice.1/4 – 20UNC306635635

4Getting StartedThese are general IMPORTANT SAFEGUARDS and certain items may not apply to all appliances.1. Read all of these instructions.2. Save the

© 2007 Victor Company of Japan, LimitedLST0629-001AVN-V25U IP CAMERAVN-V25U_EN.book Page 40 Friday, November 9, 2007 10:30 AM

5Getting Started ... 2Safety Precautions ... 2Main Features ...

6Getting Started䡵 High Picture QualityThe camera unit of this product employs a 330,000-pixel CCD (1/4") which enables high quality video surveil

7䡵 Recommended Computer SpecificationsOS : Windows XP (Professional or Home Edition) (SP2)CPU : Pentium4 1.5 GHz or higherMemory capacity: 1 GB or mor

8Getting StartedSaving Energy䢇 When this product is not in use for a long period of time, turn off the power of the system to ensure safety and reduce

9Front / Bottom / SideABack Focus Adjustment RingThis ring is used for back focus adjustment and switching the lens mount method.To operate, loosen th