JVC CA-UXG30 User Manual download pdf (Page 22)

Timer Operations

(see pages 16 and 17)

• When you unplug the AC power cord or if a power failure

occurs, the timer will be canceled. You need to set the

clock first, then the timer again.

Troubleshooting

If you are having a problem with your System, check this list

for a possible solution before calling for service.

General:

Adjustments or settings are suddenly canceled before

you finish.

]

There is a time limit. Repeat the procedure again.

Operations are disabled.

]

The built-in microprocessor may malfunction due to

external electrical interference.

Unplug the AC power

cord and then plug it back in.

Unable to operate the System from the remote control.

]

The path between the remote control and the remote

sensor on the System is blocked.

]

The batteries are exhausted.

No sound is heard.

]

Speaker connections are incorrect or loose.

]

Headphones are connected.

Radio Operations:

Hard to hear broadcasts because of noise.

]

Antennas connections are incorrect or loose.

]

The AM loop antenna is too close to the System.

]

The FM antenna is not properly extended and positioned.

Disc Operations:

The disc does not play.

]

The disc is placed upside down. Place the disc with the

label side up.

ID3 Tag on an MP3 disc cannot be shown.

]

There are two types of ID3 Tag—Version 1 and Version

2. This System can only show ID3 Tag Version 1.

MP3 groups and tracks are not played back as you

expect.

]

The playing order is determined when the disc was

recorded. It depends on the writing application.

The disc sound is discontinuous.

]

The disc is scratched or dirty.

The disc tray does not open or close.

]

The AC power cord is not plugged in.

]

Child Lock is in use (see page 15).

Timer Operations:

Daily Timer does not work.

]

The System has been turned on when the on-time comes.

Timer starts working only when the System is turned off.

Maintenance

To get the best performance of the System, keep your discs,

and mechanism clean.

Handling discs

• When removing the disc from its case, hold it at the edge

while pressing the center hole lightly.

• Do not touch the shiny surface of the disc, or bend the disc.

• Put the disc back in its case after use to prevent warping.

• Be careful not to scratch the surface of the disc.

• Avoid exposure to direct sunlight, extreme temperature,

and moisture.

To clean the disc:

• Wipe the disc with a soft cloth in a straight line from center

to edge.

Cleaning the System

• Stains should be wiped off with a soft cloth. If the System

is heavily stained, wipe it with a cloth soaked in water-

diluted neutral detergent and wrung well, then wipe clean

with a dry cloth.

• Since the System may deteriorate in quality, become

damaged or have its paint peeled off, be careful about the

following:

– DO NOT wipe it with a hard cloth.

– DO NOT wipe it forcefully.

– DO NOT wipe it with thinner or benzine.

– DO NOT apply any volatile substance such as

insecticides to it.

– DO NOT allow any rubber or plastic to remain in contact

for a long time.

To remove the speaker grilles:

Holes Projections

Speaker

grille

UX-G30[B].book Page 19 Tuesday, February 14, 2006 5:00 PM

1 2 ... 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments

JVC CA-UXG30 User Manual Page 22

Comments to this Manuals

Related products and manuals for Home audio sets JVC CA-UXG30