JVC SR-V10E User Manual Page 21

  • Download
  • Add to my manuals
  • Print
  • Page
    / 68
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 20
Masterpage:Right-NoTitle0
EN
21
Filename [SR-V10E1a-EN.fm]
Page 21 August 19, 2002 5:02 pm
Elapsed Recording Time Indication
1
Set the counter display.
Press
– –:– –
until a counter reading appears on the front
display panel.
The front display panel shows
the counter reading with “:”
lit.
2
Reset the counter.
Press
0000
before starting recording or playback.
The counter is reset to “0:00:00” and shows the exact elapsed
time as the tape runs. You can check the exact time of a
recording or playback.
Tape Remaining Time
Press
– –:– –
until the time remaining on the tape appears.
The front display panel shows
the tape remaining time with
“:” blinking.
By pressing the
– –:– –
button,
you can change display to
show the channel position*, clock time, counter reading or
tape remaining time.
* Channel position is not displayed during playback.
NOTE:
Depending on the type of tape being used, the tape remaining
time reading may not appear right away, or is not correct.
“– –:– –” may sometimes appear, or the display may blink on
occasion.
Repeat Recording
You can record programmes on one tape repeatedly.
1
Start recording.
Press and hold
7
and press
4
on the remote control, or
press
7
on the recorder.
2
Activate Repeat Recording.
Press and hold
7
and press
4
on the remote control, or
press
7
on the recorder for over 5 seconds.
The Record indicator (
) on the front display panel blinks
slowly.
3
Stop Repeat Recording.
Press
8
on the remote control or
0
on the recorder at
any time.
Pressing
9
also stops Repeat Recording.
NOTES:
Recording will be performed in LP mode even if the tape
speed is set to EP mode when you start recording.
It is possible to use the Mode Lock function (
pg. 20).
SR-V10E1a-EN.fm Page 21 Monday, August 19, 2002 5:11 PM
Page view 20
1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 67 68

Comments to this Manuals

No comments