Jvc GR-DVL1020 User Manual download pdf (Page 70)

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,

etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery

pack, AC Adapter, etc.) and wait a few minutes; and then re-connect it and proceed as usual from the

beginning.

• The power is not connected

properly.

• The battery is dead.

• The date/time is not set.

• The built-in clock battery has run

out and the previously set date/time

has been erased.

— For Tape Recording —

• The tape’s erase protection tab is

set to “SAVE”.

• The Power Switch is set to “PLAY”

or “OFF”.

• The VIDEO/MEMORY Switch is set

to “MEMORY”.

• “TAPE END” appears.

• The cassette holder cover is open.

— For Memory Card Recording —

• The VIDEO/MEMORY Switch is set

to “VIDEO”.

• The camcorder is not getting power,

or some other malfunction exists.

• Focus is set to the Manual mode.

• The recording was done in a dark

place, or the contrast was low.

• The lens is dirty or covered with

condensation.

• Connect the AC Adapter securely

(Z pg. 9).

• Replace the dead battery with a

fully charged one (Z pg. 8, 9).

• Set the date/time (Z pg. 11).

• Consult your nearest JVC dealer

for replacement.

• Set the tape’s erase protection tab

to “REC” (Z pg. 12).

• Set the Power Switch to “

AUTO

” or

“

MANUAL

” (Z pg. 17).

• Set the VIDEO/MEMORY Switch to

“VIDEO”.

• Replace with new cassette

(Z pg. 12).

• Close the cassette holder cover.

• Set the VIDEO/MEMORY Switch to

“MEMORY”.

• Turn the camcorder’s power off and

on again (Z pg. 17).

• Set Focus to the Auto mode

(Z pg. 43).

• Clean the lens and check the focus

again (Z pg. 74).

SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION

1 No power is supplied.

2 “SET DATE/TIME!” appears.

3 Recording cannot be

performed.

4 There is no picture.

5 The focus does not adjust

automatically.

CONTINUED ON NEXT PAGE

TROUBLESHOOTING

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 87 88

Comments to this Manuals

No comments

Jvc GR-DVL1020 User Manual Page 70

Comments to this Manuals

Related products and manuals for Cameras Jvc GR-DVL1020