JVC RX-6012VSL User Manual download pdf (Page 31)

28

English

Troubleshooting

Use this chart to help you solve daily operational problems. If there is any problem you cannot solve, contact your JVC

service center.

SOLUTION

Plug the power cord into an AC outlet.

Check speaker wiring and reconnect if

necessary.

Press SPEAKERS ON/OFF button correctly.

Select the correct source.

Press MUTING to cancel the mute.

Select the correct input mode (analog or

digital).

Check connections.

For analog connections, see page 5.

For digital connections, see page 7.

Check speaker wiring and reconnect if

necessary.

Adjust the balance properly (see page 11).

Connect an outdoor FM antenna or contact

your dealer.

Select a new station.

Check with your dealer to be sure you have

the correct antenna.

Check connections.

Move the antenna farther from automobile

traffic.

1. Press STANDBY/ON

on the front

panel to turn off the receiver.

2. Stop the playback source.

3. Turn on the receiver again, and adjust the

volume.

Press STANDBY/ON

on the front panel,

then check the speaker wiring.

If “OVERLOAD” does not disappear, unplug

the AC power cord, then plug it back again.

If speaker wiring is not short-circuited, contact

your dealer.

Press STANDBY/ON

on the front panel

to turn off the receiver. After unplugging the

power cord, consult your dealer.

Press STANDBY/ON

on the front panel

to turn off the receiver. After unplugging the

power cord, consult your dealer.

Remove the obstruction.

Replace batteries.

Select the correct remote control operation

mode. (See page 26).

POSSIBLE CAUSE

The power cord is not plugged in.

Speaker signal cables are not connected.

The SPEAKERS ON/OFF button is not

set correctly.

An incorrect source is selected.

Muting is activated.

An incorrect input mode (analog or

digital) is selected.

Connections are incorrect.

Speaker signal cables are not connected

properly.

The balance is set to one extreme.

Incoming signal is too weak.

The station is too far away.

An incorrect antenna is used.

Antennas are not connected properly.

Ignition noise from automobiles.

Speakers are overloaded because of high

volume.

Speakers are overloaded because of short

circuit of speaker terminals.

The built-in microcomputer is not

functioning correctly.

The receiver is overloaded because of a

high voltage.

There is an obstruction in front of the

remote sensor on the receiver.

Batteries are weak.

An incorrect remote control operation

mode is selected.

PROBLEM

The display does not light up.

No sound from speakers.

Sound from one speaker only.

Continuous hiss or buzzing during FM

reception.

Occasional cracking noise during FM

reception.

“OVERLOAD” starts flashing on the

display.

“DSP MICON NG” starts flashing on the

display.

The STANDBY lamp lights up after

turning on the power, but soon the

receiver turns off (into standby mode).

Remote control does not work.

Remote control does not operate

intendedly.

EN25-30.RX-6010&6012[US]_f 00.12.20, 2:23 PM28

1 2 ... 26 27 28 29 30 31 32 33 34

Comments to this Manuals

No comments