RK-C42WBT3Thank you for purchasing this Wall Mounting Unit.We recommend that you read this manual thoroughly before use in order to familiarize yourse
102. Place one hand on top of the plasma display to steady it and with the other hand set the Angle Adjustment Leverto 20°.* If the Angle Adjustment L
11<Instructions for Assembly, cont’d>3. Remove the Rotation Shaft Screws and Spacer Rings at the bottom left and right of the Wall Mounting Unit
12Brace the plasma display while connecting the power cord or system cables, as the display maytip over, causing injury.5. Connect the power cable and
137. Set the angle of the plasma display.Hold the upper part of the plasma display with one hand and set the display to the desired angle with the oth
141. Hold the upper middle of the plasma display and set the Angle Adjustment Lever to 0°.* If the Angle Adjustment Lever has been fastened, remove th
15<Instructions for Removing the Plasma Display, cont’d.>This task must be performed by at least two persons.Danger3. Remove the Frame Fastening
Wall Mounting Unit Exterior13120131313120131201313131202-φ52-φ82-φ52-φ82-φ52-φ82-φ52-φ82-φ52-φ52-φ82089 4920°30020208.5140101.549981.5159.516.5819020
2Assembly and Mounting Warnings● Consult authorized service personnel for the installation and attachment of this unit to the wall.This unit weighs ap
3WarningMounting the Wall UnitThe Wall Mounting Unit should be mounted to a wall that can adequatelyhold the total weight of the plasma display and th
4Frame Fastening Screws left/right(Spacer Ring + Flat Washer + Spring Washer)Frame Rotation ShaftScrews (left/right)Spacer Rings (left/right)Frame Att
5<Before Attaching Plasma Display>2. Push in the heads of the left and right Frame Removal Lever Screws a and lift up section b to remove theFra
6Instructions for Assembly1. Attach the Wall Mounting Unit w to the surface of the wall.The unit should be attached using the method most suited to th
73. Identify the Rotation Shaft Screws of the Wall Mounting Unit.Check that the left and right Rotation Shaft Screws are secure, as the Rotation Jaw o
85. Fix the Frame and Wall Mounting Unit.Combine the Frame Fastening Screws, Spacer Rings, Flat Washers, and Spring Washers (from the two pairs ofFram
9<Instructions for Assembly, cont’d>Adjusting the Angle of the Plasma Display* The angle of the Wall Mounting Unit can be adjusted to 0°, 5°, 10
Comments to this Manuals