Jvc AV 24F702 User Manual download pdf (Page 6)

REMOTE CONTROL (CONTINUED)

BATTERY INSTALLATION

2. Install two “AA” (penlight size) batteries, paying

attention to the polarity diagram in the battery

compartment.

1. Slide the battery compartment cover in the direction

of the arrow.

3. Replace the compartment cover.

BATTERY PRECAUTIONS

The precautions below should be followed when using

batteries in this device:

1.Use only the size and type of batteries specified.

2.Be sure to follow the correct polarity when installing the

batteries as indicated in the battery compartment.

Reversed batteries may cause damage to the device.

To avoid a potential short circuit, insert the “–” end first.

3.Do not mix different types of batteries together (e.g.

Alkaline and Carbon-zinc) or old batteries with fresh

ones.

4.If the device is not to be used for a long period of time,

remove the batteries to prevent damage or injury from

possible battery leakage.

5.Do not try to recharge batteries not intended to be

recharged; they can overheat and rupture. (Follow

battery manufacturer’s directions.)

6.When you change the batteries, try to complete the task

within three minutes. If you take longer than three

minutes, the remote control codes for your Cable Box

may have to be reset (see page 8).

EFFECTIVE DISTANCE OF THE REMOTE CONTROL TRANSMITTER

15 FEET

30˚ 30˚

NOTES: • When there is an obstacle between the TV and the transmitter, the transmitter may not operate.

• When direct sunlight, an incandescent lamp, ﬂuorescent lamp or any other strong light shines on the

Remote sensor of the TV, the remote operation may be unstable.

1 2 3 4 5 6 7 8 9 10 11 ... 23 24

No comments

Jvc AV 24F702 User Manual Page 6