JVC LS-M1 User Manual download pdf (Page 3)

English

Before assembling—

• Prepare a Phillips screwdriver.

• Place a large, thick cloth on the floor where you assemble the

speaker stand to protect the floor and the speaker stand.

7 Assembling the speaker stand

• Tighten the screws firmly so that no space is left between

the legs and plates.

Fix the top plate.

• Align the projection of the legs to the holes of the top plate

correctly, then attach them with three of the supplied

screws B (M6 x 16 mm).

* The side without spacer should face outside.

Fix the bottom plate and leg holders.

• Align the projection of the legs to the holes of the bottom

plate correctly, then attach them with three of the supplied

screws A (M6 x 30 mm).

Finally tighten screws A and B fully.

• Tighten them firmly and fully so that no space is left between

the legs and plates.

7 Attach the speaker on the stand

Locate the speaker properly by aligning both screw holes

of the speaker and the speaker stand.

• Do not install the speaker stand on an uneven surface or in

a place subject to vibration.

• Do not install any overweight equipment (over 10 kg) on the

speaker stand.

Fix the speaker with the supplied screws C (M5 x 28 mm).

• Do not overtighten the screws, but firmly enough to prevent

the speakers from being shaky.

Assembly Installing Speaker

Leg B (thin)

Screws A

(M6 x 30 mm)

Spacer

Bottom plate

Leg A (thick)

Spacer

Leg holder

Thick cloth

(not supplied)

Screw C (M5 x 28 mm)

Spacer

Screws B

(M6 x 16 mm)

Top plate

Leg B (thin)

Leg A (thick)

330260

632

585 1530

Unit: mm

Design and specifications subject to change without notice.

Mass: 5.3 kg each

Maximum load: 10 kg

Dimensions: See the diagram.

Specifications

EN_LS-M1[US]4.p65 04.11.4, 4:57 PM3

1 2 3 4

Comments to this Manuals

No comments

JVC LS-M1 User Manual Page 3

Comments to this Manuals

Related products and manuals for Light switches JVC LS-M1