JVC LT-26B60SU User Manual download pdf (Page 22)

ENGLISH - 21 -

Picture Mode

Picture mode OSD is displayed when BLUE

button is pressed. Picture mode can be

changed to standard, soft, and bright.

Sleep Timer

Sleep Timer mode OSD is displayed when

YELLOW button is pressed.

The Sleep Timer is used to turn the TV off after

a defined period of time after selecting this

item. The timer can be programmed between

Off and 120 minutes in steps of 10 minutes.

(Off, 010, 020, 030, 040, ... , 120)

If sleep timer is activated, at the end of the

selected time, the TV goes automatically to

stand-by mode.

Mute Indicator

It is placed in the upper middle of the screen

when enabled, and it stays there until it is dis-

abled.

To cancel mute, there are two alternatives; the

first one is by pressing the " " button, this

volume is set to the preceding value, and the

second one is increasing or decreasing the

volume level.

No-Signal Detection (TV mode)

If no valid signal detected, it takes 5 minutes

to switch to the Stand-By mode unless any

signal detected or any Remote Control com-

mand is accessed.

After a Remote Control command (if No-Sig-

nal Timer is active) the timer stops and if no

signal detected again the timer is initialized to

5 minutes and starts 3 seconds later again to

count down.

It is not valid in EXT modes.

No-Signal and Out Of Range

Detection (PC mode)

In PC Mode, as no menu is displayed, in case

that there is no PC input to the TV, it is dis-

played an OSD message:

No input signal detected

then the TV will turn to be in PC standby mode.

In PC standby mode, the green lamp blinks.

Press AV button, digit buttons or   /



 buttons to exit standby mode.

In PC Mode, if the resolution and the vertical

frequency is not supported by the concept, it is

displayed an OSD message:

Signal out of range

Volume Bar

It is displayed in the lower middle of the screen.

When a volume command is received (press-

ing  + or  - by Remote Control or

Control panel on the right side of the TV) and

no menu is active, it stays on the screen for 3

seconds, after the last volume command or

until another command is received in between.

EXT Modes

By pressing the AV button you can switch

your TV to EXT modes (except being in Tele-

text). Pressing this button consecutively will

switch the TV in one of the optional EXT

modes: EXT-1, EXT-2, EXT-2 S, EXT-3, EXT-4,

EXT-4 S and PC.

In order to quit the EXT mode press any digit

buttons or 

 or  .

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 31 32

Comments to this Manuals

No comments