Jvc HM-HDS1EU User Manual Page 93

  • Download
  • Add to my manuals
  • Print
  • Page
    / 100
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 92
Masterpage:Right-Full-NoTitle0
EN
93
Filename [HDS1EU_5.fm]
Page 93 June 21, 2001 12:30 pm
OTHER PROBLEMS
SYMPTOM POSSIBLE CAUSE CORRECTIVE ACTION
1. Whistling or howling is heard from
the TV during camcorder
recording.
The camcorders microphone is too
close to the TV.
Position the camcorder so its
microphone is away from the TV.
The TVs volume is too high. Turn the TVs volume down.
2. When scanning channels, some of
them are skipped over.
Those channels have been
designated to be skipped.
If you need the skipped channels,
restore them (
pg. 82).
3. The channel cannot be changed.
Recording is in progress. Press
9
to pause the recording,
change channels, then press
4
to
resume recording.
4. Channel settings that were made
manually seem to have changed or
disappeared.
After the manual settings were
made, Auto Channel Set was
performed.
Perform manual setting again.
5. No channels are stored in the
recorders memory.
The TV aerial cable was not
connected to the recorder when
Auto Set Up was performed.
Turn off the recorder once and
connect the TV aerial cable to the
recorder properly, then turn on the
recorder again. The recorder will try
Auto Set Up again (
pg. 14).
The fully-wired 21-pin SCART cable
was not connected between TV and
the recorder when Preset
Download was performed.
Turn off the recorder once and
connect the fully-wired 21-pin
SCART cable to the recorder properly,
then turn on the recorder again. Then
perform Preset Download again
(
pg. 16).
6. The remote control wont operate
the TV or satellite receiver.
The remote control brand setting is
incorrect.
Re-set the remote control to the
correct brand. (
pg. 49, 50)
ATTENTION
This recorder contains microcomputers. External electronic noise or interference could cause malfunctioning. In such cases, switch
the recorder off and unplug the mains power cord. Then plug it in again and turn the recorder on. Take out the cassette. After
checking the cassette, operate the unit as usual.
HDS1EU_.book Page 93 Thursday, June 21, 2001 12:30 PM
Page view 92
1 2 ... 88 89 90 91 92 93 94 95 96 97 98 99 100

Comments to this Manuals

No comments