Jvc GR-DVX4 User Manual download pdf (Page 63)

EN63

SYMPTOM POSSIBLE CAUSES CORRECTIVE ACTION

TROUBLESHOOTING

No power is supplied.

“SET DATE/TIME!” appears.

Recording cannot be

performed.

There is no picture.

Some functions are not

available using MENU/SET.

The focus does not adjust

automatically.

The cassette will not load

properly.

In the 5-Second mode,

recording ends before

5 seconds have elapsed.

• The power is not connected

properly.

• The battery is dead.

• The LCD monitor is not open

fully or the viewfinder is not

pulled out when recording.

• The built-in clock’s recharge-

able lithium battery is

discharged.

• The previously set date/time is

erased.

• The tape’s erase protection

switch is set to “SAVE”.

• The Power Switch is set to

“ ”.

• “TAPE END” appears.

• The cassette’s cover is open.

• The camcorder is not getting

power, or some other

malfunction exists.

• The Operation Switch is set to

“ ”.

• Focus is set to “MANUAL”.

• The recording was done in a

dark place, or the contrast

was low.

• The lens is dirty or covered

with condensation.

• The cassette is in the wrong

position.

• The battery’s charge is low.

• The 5-Second mode in the

System Menu is set to

“ANIM.”.

• Connect the AC Power

Adapter/Charger securely

(Z pg. 7).

• Replace the dead battery with

a fully charged one (Z pg. 6,

7).

• Open the LCD monitor fully

or pull out the viewfinder. The

LCD monitor turns on/off

when it is opened/closed at

approx. 90° while the Power

Switch is set to any position

except “OFF” if the viewfinder

is not fully pulled out.

• Connect the camcorder to an

AC outlet using the AC Power

Adapter/Charger for over 24

hours to charge the clock’s

lithium battery (Z pg. 8).

• Set the tape’s erase protection

switch to “REC” (Z pg. 9).

• Set the Power Switch to any

position except “ ” or

“OFF” (Z pg. 13).

• Replace with new cassette

(Z pg. 9).

• Close the cassette’s cover.

• Turn the camcorder’s power

off and on again (Z pg. 14).

• Set the Operation Switch to

“ ” (Z pg. 13).

• Set Focus to “AUTO”

(Z pg. 37).

• Clean the lens and check the

focus again (Z pg. 69).

• Set it in the right position

(Z pg. 9).

• Install a fully charged battery

(Z pg. 6, 7).

• Select “5S” or “5SD” in the

System Menu (Z pg. 28, 30).

If, after following the steps in the chart below, the problem still exists, please consult your nearest JVC dealer.

The camcorder is a microcomputer-controlled device. External noise and interference (from a TV, a radio,

etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery

pack, AC Power Adapter/Battery Charger, etc.) and wait a few minutes; and then re-connect it and proceed

as usual from the beginning.

CONTINUED ON NEXT PAGE

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 79 80

Comments to this Manuals

No comments

Jvc GR-DVX4 User Manual Page 63

Comments to this Manuals

Related products and manuals for Cameras Jvc GR-DVX4